Capacitor help
 
Notifications
Clear all

Capacitor help

11 Posts
4 Users
0 Reactions
6,387 Views
cenote
Posts: 350
Topic starter
(@cenote)
Reputable Member
Joined: 19 years ago
[#10768]

Been playing around with making some simple little LED spots, and now am playing with installing different type of line regulators before the array to lower the voltages down to make my resistors more efficient. My questions is I see a lot of designs on the web that use different types of values of capacitors before and after on the line voltage.

A) do I need them?

B) is there a good web site to help find values to use?

I am playing now with the LM350 Reg, and have a good grasp on controlling it with the resistors. I am using a filtered 24v DC power supply for inputs. I am using mostly 11.25v and 7.02v coming out of the regulators. Most schematics I have come show values of any where between .1uf to 1000uf before and most are showing .1 uf after. Also, some show a polarized one before these two too.

Thanks in advance for any help,
Chuck


10 Replies
Posts: 597
(@entropy)
Honorable Member
Joined: 19 years ago

If you are using DC as your power input, your only options are resistors or a step-down switching regulator.

The capacitor trick is for line-level AC.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

The input cap to the LM350 is used for input stability, and (per the data sheet) is needed if the regulator is some distance from the DC power source.

The output cap (per the data sheet) is for transient response and transient rejection. It's probably not needed if you are using the regulator just for powering LEDs, although I think that it would be a good idea to leave room for a small value part, perhaps 1 uF.


Reply
cenote
Posts: 350
Topic starter
(@cenote)
Reputable Member
Joined: 19 years ago

Thanks Phil, kinda of thought that, it works fine now, just looking to make a stable supply to LED's to prolong life as long as possible.


Reply
Posts: 597
(@entropy)
Honorable Member
Joined: 19 years ago

I guess I need a bit more clarification - Are you trying to use a series capacitor to drop the line voltage without dissipating power as described at http://members.misty.com/don/ledfaq.html#120 , or are you just asking about power supply filtering (parallel) capacitors?

You do realize that using an LM350 regulator will not make your resistors more efficient, it will just move the power dissipation from the resistors to the LM350?


Reply
Page 1 / 3
Share: