Capacitor help
 
Notifications
Clear all

Capacitor help

11 Posts
4 Users
0 Reactions
6,396 Views
Posts: 604
(@aussiephil)
Honorable Member
Joined: 19 years ago
P. Short wrote:The input cap to the LM350 is used for input stability, and (per the data sheet) is needed if the regulator is some distance from the DC power source.

The output cap (per the data sheet) is for transient response and transient rejection. It's probably not needed if you are using the regulator just for powering LEDs, although I think that it would be a good idea to leave room for a small value part, perhaps 1 uF.

Ditto

The only thing that never seems to be spelled out is just what is "some distance". is it inches, feet or many metres.

Entropy - the OP is discussing a filtered DC source of 24v.

cenote, personally i would use more series led's in your spots or lower the original source voltage.

cheers


Reply
cenote
Posts: 350
Topic starter
(@cenote)
Reputable Member
Joined: 19 years ago
Entropy wrote:
You do realize that using an LM350 regulator will not make your resistors more efficient, it will just move the power dissipation from the resistors to the LM350?

Thanks for the really cool links

Yes, my goal here is I am playing with 5w 700mA LED's, and when I lower my voltage down to near what the total forward voltage is, my resistor sizes can drop way down from 5w down to below 1w.


Reply
cenote
Posts: 350
Topic starter
(@cenote)
Reputable Member
Joined: 19 years ago
aussiephil wrote:
personally i would use more series led's in your spots or lower the original source voltage.

cheers

Problem, is @ 5watt, gets to be power hogs. All ready built a flood to do what I was looking for brightness, now working on getting the voltage perfect to prolong life and still have stability and brightness.


Reply
Posts: 604
(@aussiephil)
Honorable Member
Joined: 19 years ago
cenote wrote:Problem, is @ 5watt, gets to be power hogs. All ready built a flood to do what I was looking for brightness, now working on getting the voltage perfect to prolong life and still have stability and brightness.

now if we knew this upfront then answer would be different.

1. Regardless of where/how you do it, excess voltage will be converted to heat.
2. 3W and 5W LEDS should always be driven with constant current sources.
3. Small variations in Vf just cause too many problems with 3/5W Leds when using a voltage source.
4. If you have to convert from 24v to something closer to what you need then a switch mode solution will be significantly better.
5. Lowering the original source voltage would provide much greater overall efficiency.
6. if you can't do 5 then use a simple switcher from national semi to do the first voltage conversion then wire the lm317/lm350 as a constant current regulator.

cheers


Reply
cenote
Posts: 350
Topic starter
(@cenote)
Reputable Member
Joined: 19 years ago
aussiephil wrote:
6. if you can't do 5 then use a simple switcher from national semi to do the first voltage conversion then wire the lm317/lm350 as a constant current regulator.

cheers

That's how I have it, just checking on the whole capacitor issue. Most "samples" schematics show that some sort of capacitor arrangement before and after Lm350's

Always great advice form you folks down under, thanks
Chuck


Reply
Page 2 / 3
Share: