Last seen: Nov 18, 2026
I've been looking to do this also. Looking at space considerations I am assuming everyone used square pixels? Most J channel doesn't have enough room ...
My ESPixelsticks are in pill bottles, holes for wires in the caps, and I mount them upside down. I have one in a pill bottle, in a RBL. Plastic conta...
Makes it all worth it!
Haven't had any warpage. It does take a while to cool and get the build off, it stays warm for while.
Best thig I did to my Ender 3 is a Borosilicate glass plate, fixed any levelling issues. Others here have used glass or mirrored glass plates.
Using Borosilicate glass plate on my Ender 3, I use a quick shot of hair spray to make it tacky.
I use a borosilicate glass plate. Always flat, best prints ever.
The input to the Renard boards is RS-232/RS-485, not ethernet. It just uses RJ-45 connectors for convenient cable connections. If you actually have a ...
I had a similar issue. Had poor sound quality, got a Rocat Juke USB sound adapter. When it was plugged in, lost one of my serial dongles. Pull sound U...
MartinMueller2003 wrote:Thats what I thought. You should switch to multicast for the show data. Unicast will get all bound up and retries will cause o...
MartinMueller2003 wrote:multicast in use? No, unicast. I was playing last night and increased the client timeout to 30. seemed stable. Going to watc...
I run a continuous loop.
I like option 2, I currently use the zig zag in the controller.
Prayers for Brian and family, wishing for a speedy recovery
