I was quite pleased with running my HLS sequences through the Pi. The only problem was a scheduling issue but they got that fixed. I would like to se...
Oh it went over just about everything you could image when doing automated shows. As i said it covered WOC, The fireworks show, Fantasmic and several ...
ErnieHorning wrote:So in essence these chips are likely to be specialized microcontrollers that are ROM based with a few bytes of flash memory for the...
For those in the US here is the Amphenol link on Mouser. I for one would love to use DeviceNet for Power over DMX application as the cable specificat...
So far my understanding is there is two addressing modes, cascade and programmed. There is a programmer but I'm trying to get the programming protocol...
I assume that show cost a few thousand to put on. I get a kick that each show at Disneyland cost over $15K. I'd love to see their launchers since I un...
I don't think they have HDPE for 3D printing yet. They do have ABS but I think it takes a different head. So now were going to need 3D printers. That ...
Measure across the face of the Male end of the connector.
budude wrote:Personally I see no advantage at all to having a DMX over 28xx pixel unless you just need a string or two and already have a DMX dongle.....
I think I saw one in a data sheets Ray sent me a while back. I think they were for the 13.5 mm connectors but I need to check with Ray.
Without being reprogrammed they should work fine with the E68X. The only issue I see is if Jim allows you to go past 170 pixels. If he can or modifies...
Park, as in Anahiem? Oh Yea, OCFA would be none to please with fire cannons. I believe you need a Fire Marshal around when using them in a close envi...
Got a call from DHL, the new TC string will be here in the morning.
Livermore-Dad wrote:He only talks to timon 🙂 Sell anyone anything , but if there are issues, well ya you are on your own.. We need to figure out the ...
