Excellent job. Was expecting the upstairs window to have a goul cross the room in the darkness and peek out the window. Can't wait to see next years...
This seems to work in the search box when already on Facebook. Christmas Before July
I guess cost is relative. When deciding to buy a dimmer pack or the spec for an installation on a severe budget, the dimmer pack won. The 3 pin XLR ...
If you have the part number for the transmitter output transistor, you may get quick results ordering a replacement part from Mouser.
I don't recommend downloading the entire spec. It covers every bit of the protocol, drivers, grounding, wire, start codes, etc. Just rewire the disp...
I'll jump in and answer a few questions and help make repairs by a suggestion that does not require replacing the existing wire or changing the layout...
A word of caution on the F connector attenuators. Verify the power rating. Since you are trying to dump most power as heat in the device, it will co...
Lots of good questions. Starting with CAT 3. It is not a super high frequency wire, but the DMX is specified to use shielded twisted pair of about 12...
A properly strung and terminated DMX string can be very long, so no excuses for having stubs. Unlike pixels, DMX does not regenerate the data and sen...
J-Pole antennas are much longer than a 1/2 wave dipole, but perform very well and are not hard to tune. I too recommend them if you can hide a larger...
The 1/4 wave has a ground plane (the 3 legs) that are active elements and the tips must not touch anything for it to work correctly, eg, mast mount it...
Many MATV (master antenna) suppliers have VHF only antennas that include the FM band. Some have FM only antennas. The antenna if it does not include...
That is right on. When you fuse a string of 100 for example, one fuse for the entire string is the way to go. Feeding fused power to both 50 pixel se...
Well done. Pretty much confirms RGB currents are about the same for most pixels. Due to the differences in effeciency, this would explain why white ...
When lots of pixes are used, such as in a matrix, injecting power right at the matrix is best. For example if you have 16 rows of 50 pixels, power an...
