Tabor
@tabor
Estimable Member
Joined: Dec 24, 2008
Topics: 8 / Replies: 106
Reply
RE: 2009 LedTriks Panel PCB CoOp #1

My boards have not arrived yet and was just wondering if the other Aussies has recieived theirs?

18 years ago
Forum
Reply
RE: Bargains.

Jeremy Did you end up getting what you paid for? I grabbed a heap of boxes from and received about half. I emailed Jason many time and every time he...

18 years ago
Forum
Reply
RE: 2009 Portaflood PCB COOP

Toodles posted a video here. Last post on this page.

18 years ago
Forum
Reply
RE: Retinning solder tips

Give the tip a good clean and then with the solder iron hot try to cover the tip with a larger blob of solder. Cool the tip rapidly in wet sponge so ...

18 years ago
Topic
18 years ago
Forum
Replies: 1
Views: 2431
Reply
RE: Need a wireless dmx bridge thingy

I have been playing with the Xbee modules alot with the Renard boards lately. While it is not possible to test the higher speeds on the renard I was ...

18 years ago
Forum
DMX
Reply
RE: an emergency...i think

Thats correct. There is a 5 volt rail that runs all around the board. It is the same 5 volts for all components.

18 years ago
Forum
Reply
RE: an emergency...i think

If the trace that I have circled in the attached photo is the one you are talking about, then that is is not ground but actually your 5 volt rail. Yo...

18 years ago
Forum
Reply
RE: AC-DC Power Supply Plans

Here is a link to a power supply in it most basic form. It uses normal voltage regs to supply static voltages and an LM317 to provide a variable outpu...

18 years ago
Forum
Reply
RE: Wireless/Bluetooth Solution?!?

Dont know if they would be fast enough for dmx . Sparkfun also sell the xbee module which is cheaper, faster and will give greater distances. XBee is...

18 years ago
Forum
Reply
RE: Ren 16 "Aussie BOM"

I was looking at the photos and suspected the left side was different from the right. I even started a post and then deleted thinking, nah that cant b...

18 years ago
Forum
Reply
RE: Ren 16 "Aussie BOM"

Possibly could be a problem with the fuse going high resistance, do a swap see if it follows.

18 years ago
Forum
Reply
RE: Ren 16 "Aussie BOM"

Would both the resistor networks be in the right way?

18 years ago
Forum
Reply
RE: Need a wireless dmx bridge thingy

Series 2.5 of the xbee modules are out. They come in two versions. The pro 50mW version which they say can go for a mile (1600m). And the standard ...

18 years ago
Forum
DMX
Reply
RE: It's hot

Dont know which I would prefer. In Melb, Syd, or SA with temps above 40C or in QLD where 60% of the state is affected by floods.

18 years ago
Forum
Page 5 / 8