steve123
@steve123
Estimable Member
Joined: Nov 18, 2019
Topics: 5 / Replies: 181
Reply
RE: Automatically restart fppd daemon after upload

Thank you. I will have a look at FPP Connect.

6 years ago
Forum
Reply
RE: Video of 12v regulated pixels catching FIRE

I cannot definitively make out the layout of the other side of the board. The WS2811 IC is next to the hole so it is unlikely the GND trace can go the...

6 years ago
Reply
RE: Video of 12v regulated pixels catching FIRE

Does anyone know what the purpose of that hole in the PCB is?

6 years ago
Reply
RE: Video of 12v regulated pixels catching FIRE

Here are the parameters used for the analysis from the Digi-Key calculator. Also note, I have not dissected the pixel so I am not sure if there is an...

6 years ago
Reply
RE: Video of 12v regulated pixels catching FIRE

I posted this over on the FB forum. Here is a summary of some analysis I have done of the square pixel design. Took this shot of my 5V Ray Wu square...

6 years ago
Reply
RE: Pixel string wire gauge

There was a recent report of a fire caused by a defective pixel on the xLight support group on FB. Reading that thread it appears there have been sev...

6 years ago
Reply
RE: Video of 12v regulated pixels catching FIRE

I read in the xlights support group on FB about a pixel fire as well.

6 years ago
Topic
Forum
Replies: 3
Views: 3036
Reply
RE: Teensy 4.1 E1.31 receiver/controller

Many of the controllers have a few "differential" transmission ports for remote props. These are typically RJ45. There are a few controllers only ha...

6 years ago
Forum
Reply
RE: Teensy 4.1 E1.31 receiver/controller

Have a look at scooter_seh's github page for his open source controller (Beaglebone based). This is how I understand most people expect the controlle...

6 years ago
Forum
Reply
RE: Controller Yard Stand Recommendations

Ruppro wrote:If you are using the CG cases they have standoffs on the back, usually 2 at the top, I drill an 1/8" (maybe smaller 3/32"?) through the s...

6 years ago
Reply
RE: Wire Gauges

No problem connecting the 18 AWG pigtails to the pixels. As an aside, were the pixels you purchased manufactured in China? Have you measured the g...

6 years ago
Reply
RE: Pixel string wire gauge

Stormyblade wrote:I think that we as a group are always quick to help someone with some tips, gotchas, and concerns when we see that someone could pos...

6 years ago
Reply
RE: Pixel string wire gauge

XmasinVancouver wrote:Steve don't misunderstand angus and bwinter, they aren't saying safety does not matter, and that electrical codes aren't there f...

6 years ago
Page 9 / 13