As some of you noticed from my other post, I am taking my 100k static display and finally putting it to a light show. I was lucky enough to purchase 15 LOR controllers from a friend of mine for an amazing price. I'm currently looking for good ideas on how you guys mount your control boxes in your yard. I have just under 2 acres that I decorate, so mostly looking for mounts that would stand out in the yard and not mount to the house. Pictures and ideas welcome!
Thanks in advance for helping out the new guy. 🙂
I mount my megatree controller and power supplies in CG1500 boxes and secure them to the center pole with hose clamps. For stuff on the front lawn, I'll make a hole with a concrete stake and then sleeve it with PVC. Black iron pipe or galvanized pipe or EMT goes into the sleeve, and other boxes are mounted on that. In the off season, I put a cap on the PVC sleeves and they become invisible when the grass grows over them.
1/2" rebar, 2' length pounded into the ground about a foot (some are only 1' and in the ground about 6"). 1/2" PVC slipped over the rebar (length as needed) w/ a screw neat the top to hang the controller case on.
If you are using the CG cases they have standoffs on the back, usually 2 at the top, I drill an 1/8" (maybe smaller 3/32"?) through the standoffs (but not into the case) and take a length of coat hanger wire that will fit between the standoffs w/ some to spare, slide it through the holes and bend the ends so it can't pull out, and that is the hanger for the cases, run a Zip tie through a hole in a standoff on the bottom around the PVC to keep it all in place.
There have been some years where the ground was frozen extremely hard and I used cinder blocks. This is already looking to be one of those kind of years too.
I really should take some pictures of my boxes...
Anywhooo, I have CG-1500 boxes and made simple stands out of 1/2"PVC pipe. I drilled small holes in the bottom of the CG-1500 and the PVC pipe, ran some #4 or #6 bolts through the bottom and the pipe, and used lock washers and nuts to hold everything tight. The "foot" of the stand is just a rectangle made of PVC.
For my mega tree I just did what Kensington did - used hose clamps and silicone to seal the back where I drilled for the hose clamps to slide through.
