Controller Yard Sta...
 
Notifications
Clear all

Controller Yard Stand Recommendations

20 Posts
15 Users
0 Reactions
8,807 Views
mikeh65
Posts: 794
(@mikeh65)
Prominent Member
Joined: 19 years ago

I also use either Harbor Freight ammo boxes or some form of CG box for my controllers. The ammo boxes sit on the ground and do not need a mount. I will add a yard spike or large galvanized nail to make sure it stays upright. As for my CG boxes. As stated before, they have stand-offs on the back. These stand-offs are placed to line up with holes of a standard fence post https://www.homedepot.com/p/Everbilt-1-25-in-x-75-in-x-3-ft-Green-14-Gauge-Steel-U-Fence-Post-901153EB/205960881 from your big box store. I will drill a hole through the box from the inside, add a 2.5 to 3" bolt with a rubber washer on the inside, and a nut to the back to keep the bolt in place. Then drive the fence post in the ground, slide on the box and wing nuts to hold it. If needed, I will cut the extra fence post off to mount the box closer to the ground. This makes for an easy and reusable mount for many years. It also means I can remove the box and leave the post if needed when they get frozen in.


Reply
Posts: 32
Topic starter
(@milehighsanta)
Trusted Member
Joined: 10 years ago

Thanks everyone! Some great ideas shared. I guess I also forgot to mention that I’m in the mountains of Colorado and will need all my stands to be able to keep above the snow. I do like the fence post idea could work.


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

I use hose clamps on my cg cases onto 3/4 pvc. I drive rebar into the ground and slide the pvc over the rebar.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

The back of the CG - 1500 has a pipe holder built in. We take a metal strap, through the holder's slots (you have to cut them to allow the straps to go through- but that is easy) and then we mount the controllers to the tree's center pole. For trees and other "pipe centric" props, this has worked now for 7 or 8 years. We do take the precaution of putting silicone along where we cut to seal the box. Even on those that we didn't do this, there has not been any problem.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

If you don't like the look of boxes in the yard try this. Garbage cans with ribbons. A few inches from the bottom drill 2 holes to insert the ends of small bungee cords then use a tent stake on each side. Loop the bungee cord on the stake and you have a christmas present which will waterproof your box and connections. Here are pics of a BUD box and cover.

Sent from my SM-T710 using Tapatalk


Reply
Page 2 / 4
Share: