Controller Yard Sta...
 
Notifications
Clear all

Controller Yard Stand Recommendations

20 Posts
15 Users
0 Reactions
8,808 Views
Posts: 186
(@steve123)
Estimable Member
Joined: 7 years ago
Ruppro wrote:If you are using the CG cases they have standoffs on the back, usually 2 at the top, I drill an 1/8" (maybe smaller 3/32"?) through the standoffs (but not into the case) and take a length of coat hanger wire that will fit between the standoffs w/ some to spare, slide it through the holes and bend the ends so it can't pull out, and that is the hanger for the cases, run a Zip tie through a hole in a standoff on the bottom around the PVC to keep it all in place.

Brilliant ... I was wondering how to mount a CG on my roof for a diff receiver and power distro. I can use a brick clip on the chimney and hang the CG-1500 on that using this technique. Sweet. Thanks for the tip.


Reply
Posts: 92
(@curtinti)
Estimable Member
Joined: 7 years ago
pmiller wrote:If you don't like the look of boxes in the yard try this. Garbage cans with ribbons. A few inches from the bottom drill 2 holes to insert the ends of small bungee cords then use a tent stake on each side. Loop the bungee cord on the stake and you have a christmas present which will waterproof your box and connections. Here are pics of a BUD box and cover.

Sent from my SM-T710 using Tapatalk

Nice idea. I was thinking about building small boxes with the back exposed out of plywood and painting them to look like presents but if it covers it completely doesn’t this defeat the purpose of venting the enclosure? Unless the back of the garbage can has large holes cut out to allow air in.

Sent from my iPhone using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
curtinti wrote:Nice idea. I was thinking about building small boxes with the back exposed out of plywood and painting them to look like presents but if it covers it completely doesn’t this defeat the purpose of venting the enclosure? Unless the back of the garbage can has large holes cut out to allow air in.

Sent from my iPhone using Tapatalk

The bottom of the garbage can is about 2 inches above ground to allow airflow.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 32
Topic starter
(@milehighsanta)
Trusted Member
Joined: 10 years ago

Nice idea with the trash can!


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

I use PVC stands

21835

21834

Reply
Page 3 / 4
Share: