MikeKrebs wrote: This is really the issue. A spec is a spec. It isn't an opinion.Just excuses for not doing the right thing.
But why not just be truthful about the specs?
Indeed.
I would like to have some certainty I know the specifications of what I purchased so I can use the product properly and safely. I can learn to work around the limitations imposed by the 22 AWG wire. It would have been nice to know ahead of time, before I ordered the pixels, that was the case. That 18 AWG specification was a differentiating specification and the reason I paid extra for the strings.
With respect to the number of pixels, I am using 5V pixels and so it is a bit easier to deal with this issue because I am already planning injection that limits the maximum current in my strings to 3A (50 pixels). However, the users of 12V pixels may be at greater risk since they likely plan their power injection using a 100 pixel modulus. A string of 100 pixels at full brightness is 6A. And if you push more than 100 pixels well things can get dangerous pretty quickly since power dissipation is the square of the current. So, a doubling of the current is four times the power dissipation in the wire. A tripling of the current is 9 times the power dissipation in the wire.
There are a few things the vendors could do to address this:
1. Increase with wire size and actually make it 18 AWG.
2. Use a silicone based insulation rated for a higher operating temperature (105 or 230 degrees C) instead of using PVC rated for 60 C.
3. Embed DC/DC converters into the string (similar to how they do for strips) so you run the string at 12V and the current consumption more than halved.
XmasinVancouver wrote:Steve don't misunderstand angus and bwinter, they aren't saying safety does not matter, and that electrical codes aren't there for a reason.Sent from my SM-N960W using Tapatalk
Yeah, I think I understand what they are saying. I debated whether or not to even bring up the subject up because there is likely very little we can do individually to stop this behaviour. What might really help this hobby is if one of the mainstream retailers started to take a serious interest in this (Home Depot, Lowes, Walmart, etc). A major buyer could insist that quality standards are met and would have the wherewithal to perform quality inspections before the pixels left the factory. The problem is it is a highly technical undertaking to put this kind of thing together so not something likely to catch their attention.
Stormyblade wrote:I think that we as a group are always quick to help someone with some tips, gotchas, and concerns when we see that someone could possibly be putting themselves into harm's way. My other thought is that if you are concerned about what you are receiving as a product, use this community to ask questions, and, odds are that someone here has run into a very similar situation and can help with making sure you aren't going to fry anything, including your home and, more importantly, YOU.
Being new to this hobby I have found the community to be exceptionally patient and willing to provide tips and assistance. It has been an amazing experience.
There was a recent report of a fire caused by a defective pixel on the xLight support group on FB. Reading that thread it appears there have been several fires.
Another concern I have been mulling is that the additional temperature rise due to the wire size issues may cause failure of the pixels.
