michaelc
michaelc
@michaelc
Noble Member
Joined: May 30, 2007
Topics: 128 / Replies: 1412
Topic
Replies: 24
Views: 6065
Reply
RE: Upgraded E681 help

Brian, I just want to confirm. If I put the jumpers to DMX then the pinout is: 1:D+, 2:D-, 7:GND. Is this correct?

11 years ago
Reply
RE: Upgraded E681 help

It is now clear that the first post Christmas project for me will be to inventory all my miscellaneous harware that I have laying around my basement o...

11 years ago
Reply
RE: Upgraded E681 help

Yes the E681 is configured for 12v pixabulbs so I have to put the parts in. The pixels will be Dmx and powers separately with 5 v through a Dmx pixel ...

11 years ago
Reply
RE: Upgraded E681 help

Are these the little buggers you are talking about? Anything I need to know to configure them? I notice some are missing a transistor and two caps.Sen...

11 years ago
Reply
RE: Upgraded E681 help

budude wrote:I have five upgraded E681's (I call them E681-12's) - they configure the same as the E682's. If you need balanced outputs, I created a pl...

11 years ago
Reply
RE: Upgraded E681 help

I figured it out after the last post. I went back and rechecked all the universe start numbers. There was a conflict between the FPP output settings...

11 years ago
Reply
RE: Upgraded E681 help

So I made the switch and consolidated all the controllers. I tested the E681.5 and the channels appear to be correct on the mega tree. I do NOT have...

11 years ago
Reply
RE: Upgraded E681 help

So if I interpret, you have to assume you are using up the entire universe before it assigns the next universe. In essence a string has to span univer...

11 years ago
Reply
RE: Upgraded E681 help

Before I go messing up my configuration, does the attached look like what I'm describing. Assuming the existing 12 ports are collapsed an contain 50 p...

11 years ago
Reply
RE: Upgraded E681 help

Actually, my end goal is to drive 300 pixels of Ws2811 5050 strips. (4 arches of 75 pixels each). If there is a way to do that using the extra capaci...

11 years ago
Topic
Replies: 19
Views: 5236
Reply
RE: LED Christmas tree

Umtrying to get my 10 year old into soldering. This might be a nice starter projectSent from my bat phone using Tapatalk

11 years ago
Forum
Reply
RE: ESPixelStick - E1.31 WiFi Pixel Controller

Like one of these? Interesting that the waterproof one is less than the non waterproof one

11 years ago
Reply
RE: ESPixelStick - E1.31 WiFi Pixel Controller

I'm looking for a good source and model of buck converter to use on these. Does anyone have a link? I know there are some converters that don't play ...

11 years ago
Page 10 / 103