michaelc
michaelc
@michaelc
Noble Member
Joined: May 30, 2007
Topics: 128 / Replies: 1412
Reply
RE: Seeeduino on sale for $13.50

Aren't the seed shields the ones that aren't reliable?Sent from my iPad using Tapatalk

11 years ago
Forum
Reply
RE: ESPixelStick - E1.31 WiFi Pixel Controller

I've got a Falcon configuration question. I have 2 universes using the ESPixel. U202, U203. They are used to control 4 arches. The arches are NO...

11 years ago
Reply
RE: ESPixelStick - E1.31 WiFi Pixel Controller

The initConfig didn't work. I even hard coded the ip, mask and gateway in the reset code. I ended up just reprogramming my router to the messed up a...

11 years ago
Reply
RE: ESPixelStick - E1.31 WiFi Pixel Controller

I need to clear the configuration on my ESP. I tried adding the initconfig(); as explained above but received the following message. ANy ideas? I a...

11 years ago
Reply
RE: SMD Soldering Station Suggestions

Deon, if hot air is just ok and vacuum is a joke are you recommending it solely on the smoke absorber?Sent from my bat phone using Tapatalk

11 years ago
Reply
RE: SMD Soldering Station Suggestions

I was looking at this one. Does anyone have any feedback? It's a few dollars more than the Sparkfun one but it includes a pre-heat option.

11 years ago
Topic
Replies: 13
Views: 18433
Reply
RE: ESPixelStick Group Buy - E1.31 WiFi Pixel Controller kit

Problem was a bad FTDI board. New board programmed without errorsSent from my iPad using Tapatalk

11 years ago
Forum
Reply
RE: RenardESP Information Thread

Are you extending the antenna outside the CG1500 or just leaving it inside the CG1500

11 years ago
Forum
Reply
RE: ESPixelStick Group Buy - E1.31 WiFi Pixel Controller kit

I got one to program and was able to bring up the web page and verify configuration. I swapped out the antenna to program the next one (after powerin...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

So I have a question. Where is everyone placing their wireless routers with respect to their displays. (Inside House/Outside House? On ground/mounted...

11 years ago
Forum
Reply
RE: ESPixelStick Group Buy - E1.31 WiFi Pixel Controller kit

I ordered a new ftdi since it was multiple boards. It should be here today and I'll re flash Sent from my bat phone using Tapatalk

11 years ago
Forum
Reply
RE: 10W RGB LED driver boards (Ren/dumb RGB, WS2811, DMX)

I'd love to combine these boards with the ESPixel WiFi board for a truly wireless solution (except for DC Power). I'll see if they fit in the outer ch...

11 years ago
Reply
RE: ESPixelStick Group Buy - E1.31 WiFi Pixel Controller kit

Using a PC power supply 12V for this line. Jumper is set to 12V. Jumper on the FTDI programmer is set to 3.3V The FTDI is from Komby.

11 years ago
Forum
Reply
RE: ESPixelStick Group Buy - E1.31 WiFi Pixel Controller kit

Okay, got arduino running right. sketch compiles without issue. When I upload it, it looks like it's going nicely then I get this error: Sketch uses...

11 years ago
Forum
Page 11 / 103