justaplaneguy
@justaplaneguy
Eminent Member
Joined: Nov 8, 2021
Topics: 5 / Replies: 8
Reply
RE: Help - Troubleshooting Mega Tree

I got it all fixed. I had 1 bad controller, And the controller settings didn't match xlights, didn't realize you had to do both.

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

memphislights2 wrote: post your xlights config for the controller and the definition for your tree Also, do you have to upload your configuration or ...

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

Not a pixelprop controller. A "PixelPop" controller. These are DIY built ESP8266 wifi controllers that are programmed with the Epixelstick v3.0 softwa...

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

I drew out the tree and how it's connected. I could really use help here because no matter what I've tried for the controller or the layout, I can't s...

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

It has everything to do with the layout and the controllers. I can't seem to setup the Mega Tree correctly in xLights. It either wants to show the lig...

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

Ok, So there does seem to be a problem in my setup. I want Controller 1 to operate String 1 as one really long string. When I do an RGB Cycle test, A-...

2 years ago
Reply
RE: Help - Troubleshooting Mega Tree

ErnieHorning wrote: It sounds like you have blue and green swapped in the controller. I don't use PixelPop controllers but every controller seems to ...

2 years ago
Topic
Replies: 10
Views: 1625
Reply
RE: Tubes / Arch with LEDs

MartinMueller2003 wrote: You may be surprised. Many people use a thin walled PEX pipe and run the pixels inside it. It makes the pipe light up nicely....

2 years ago
Topic
Replies: 7
Views: 3915
Topic
Forum
Replies: 3
Views: 2323
Topic
Forum
Replies: 1
Views: 2229