I drew out the tree and how it's connected. I could really use help here because no matter what I've tried for the controller or the layout, I can't seem to get this to work. The only time it gets the right colors, is if I set the controller to "Auto Size", however, then the tree only lights up the first 170 pixels for each controller.
What pixelprop controllers do you have that only have a single output?
Normally a mega tree is built with the connections at the bottom of the tree.
While its a busy time and you might have to wait a bit, the xLights zoom room should be able to help.
https://zoom.us/j/175801909?pwd=ZU1hNzM5bjJpOGZ1d1BOb1BzMUFndz09
Not a pixelprop controller. A "PixelPop" controller. These are DIY built ESP8266 wifi controllers that are programmed with the Epixelstick v3.0 software (you can actually buy circuit boards that you solder the components to on this forum). When you construct the controller and the connections to it, you end up with a Voltage Input, a 3 Wire RGB output, and an extra 2 Wire Voltage output for power injection.
Article here --> https://www.instructables.com/WiFi-Controlled-Christmas-Lights-With-ESP8266/-
Shows what the controller board and finished controller looks like right at the top).
I have run this setup once before (about 3 years ago) but re-built my strands this year because I was using 3" spacing the last time, and this time I used 1" spacing (more lights, etc.). It worked flawlessly. That said, since it's been some time since I've picked xLights back up again, I'm having some issues getting xLights to talk to the lights correctly (or rather, address the larger strings).
post your xlights config for the controller and the definition for your tree
Also, do you have to upload your configuration or manually setup channels on the pixelpop?
memphislights2 wrote:
post your xlights config for the controller and the definition for your treeAlso, do you have to upload your configuration or manually setup channels on the pixelpop?
Actually, just as I was testing, I at "least" got the lights addressing and performing the right colors as they are supossed to. That problem was resolved by logging into each controller's web page separately, changing the universe boundaries to coincide with the controller setup in xlights to 510, and the start universe to the same universe as setup in xlights controller setup.
This at least resolved this problem. I never had to do this before, whatever I put in Xlights as the controller setup automatically flowed over to the controller itself.
Now, however, I seem to have an issue specfically with Controller #2, as it's lagging and getting a bunch of sequence errors. I think it's either the board or the programming of the board. I'm looking into it....

