JetMech
@jetmech
Eminent Member
Joined: May 29, 2007
Topics: 1 / Replies: 21
Reply
RE: Computer PSU

ATX power supplies are "switch-mode supplies"; they must always have some load to operate properly. If you can find the datasheet it should list the m...

19 years ago
Topic
Forum
Replies: 2
Views: 2418
Reply
RE: How can I test the load on my different circuits

Identify the outlets on the circuit, either calculate or measure the wattage of everything plugged into the outlets and add it all up. You could al...

19 years ago
Reply
RE: Gremlin is back

You may have better luck if you post this in the Grinch Forum. As busy as things are this time of year it's hard to keep up with all the posts on the...

19 years ago
Forum
Reply
RE: Why only 4 channels?

mark wrote:What I'm curious about is why only four channels for each cat5 when there are eight wires in the cable? Because .... Sean Bowf built it a...

19 years ago
Reply
RE: Basic Diagram

Now can you create an image map so that when you click on an item it takes you to the appropriate page in the wiki? 😈 John

19 years ago
Reply
RE: Should I buy now for 2008?

Common elements of all the systems are the computer, the SSR's, and power. I would consider obtaining a fast "show" computer that is for nothing else....

19 years ago
Reply
RE: 12 port parallel port controller

Macrosill wrote:Good idea JetMech!!! Yes, but it's not mine. There is a howto on CC: I was just reading the ChristmasWiki entry "Electronics Hardw...

19 years ago
Reply
RE: 12 port parallel port controller

You could use a couple of ULN2803's to invert the signal and act as a buffer between the SSR's and parallel port. Same use as in some 595 designs, jus...

19 years ago
Reply
RE: Basic Parallel Port Relay Board (K74) Help

jpettit wrote: are the relays just bad? Spec say each relay can handle 10 amps using 110 voltage, which I am well under. Any suggestions would be appr...

19 years ago
Reply
RE: Driver Help

I am no expert when it comes to electronics, but I have read and learned a lot in the last couple of years in this 'new' hobby. One is that there are ...

19 years ago
Reply
RE: Driver Help

The MOC3021 is a 15mA part where the MOC3023 is a 5mA part. The typical forward voltage is 1.15v with a max of 1.5v. Using the 300 Ohm resistor in you...

19 years ago
Reply
RE: Wanted - setup ?

And then there is the issue of liability. If someone sells a product and that product causes someone's house to burn down.... who pays?

19 years ago
Reply
RE: Allegro Chip vs. MB15027GN

Most computer case fans have a pass-through pigtail they use to tap into the 12v power of a hard drive connector. If you can find one from an old comp...

19 years ago
Forum
Reply
RE: Odd laggy behavior tonight

Could your anti-virus/spyware software have been doing a full scan in the background?

19 years ago
Forum
Page 1 / 2