Driver Help
 
Notifications
Clear all

Driver Help

12 Posts
5 Users
0 Reactions
5,545 Views
Posts: 22
(@jetmech)
Eminent Member
Joined: 19 years ago

I am no expert when it comes to electronics, but I have read and learned a lot in the last couple of years in this 'new' hobby. One is that there are no guarantees. The parallel port was designed for printers, not driving LED's, their capabilities vary greatly from computer to computer. Google "parallel port current output" and you will find about 2,300,000 English pages for your reading pleasure. Here is an excerpt form just one.

http://www.epanorama.net/circuits/parallel_output.html

The outputs are designed so that they give at least 2.4V at 2.6 mA load. This 2.6 mA figure is for ordinary LS-TLL circuits used, the LSI implementations used in many computers can give more or less. For example quite popular (few years ago) UM82C11-C parallel port chip can only source 2 mA.

The NTE3048 is also a max 15mA part (with 8mA typical).
From the Datasheet:

Note 4. The NTE3048 is guaranteed to trigger at an IF value less than or equal to max IFT. Therefore,
recommended operating IF lies between max IFT (15mA) and absolute max IF (60mA).

John

Edit: Yet another reference
http://www.beyondlogic.org/spp/parallel.htm

The output of the Parallel Port is normally TTL logic levels. The voltage levels are the easy part. The current you can sink and source varies from port to port. Most Parallel Ports implemented in ASIC, can sink and source around 12mA. However these are just some of the figures taken from Data sheets, Sink/Source 6mA, Source 12mA/Sink 20mA, Sink 16mA/Source 4mA, Sink/Source 12mA. As you can see they vary quite a bit. The best bet is to use a buffer, so the least current is drawn from the Parallel Port.

Reply
Posts: 7
Topic starter
(@jordan)
Active Member
Joined: 19 years ago

thank you all for your help, i have managed to get 8 channels up and running.


Reply
Page 2 / 2
Share: