I have spreadsheets in my google drive where I keep all my display info. Props, channel counts, controller ports, power usage per psu etc. I can pull ...
I got my 6" strings from HolidayCoro.
Thanks for everyone's input so far. My P10 parts should be arriving any day and I'll do some practical testing soon. I think I may end up taking the s...
Fpp will use the GPIO number. The specs for your relay should list what voltage is required.
I think you have the wrong pins listed, "pin 4" is not the same as "GPIO 4". Use this pic to configure FPP with the GPIO pins you used. Also, is your ...
jchuchla wrote:the only time I've ever seen a flash in the alternate effect is if you have the timing set to an even multiple of the update interval (...
I had a similar issue to this last night. I made a layered wipe effect to go from red to white to blue to red to white to blue. Each wipe takes 2 seco...
pburton wrote:My Pi with FPP has a timer on its power connection and has a shutdown script running 30 minutes before the timer turns the power off. Th...
I bought one of these transmitters from ebay a couple weeks ago (still waiting for it to arrive). Do you guys leave yours powered on all the time? ...
I've been using "set level" too, why is "pulse" better?
It sounds like you got a mechanical relay where I have a solid state one, thus the difference in ratings. The above advice for designing around 15 amp...
My SSR is rated for 2 amps per relay, total of 16 amps at max. I built mine with a max of 16 amps in design, but I'm only using .5 amp per outlet and ...
Pcguy17 wrote: 1> Power feeds? only one, as main power. it have 5v from the PI then the 110 from the plug in. 2>Amps, not sure i have to test some li...
I used this SSR: it only switches the line or neutral, not both. I chose to switch the line. I tried to draw out a rough diagram of how I did it. Ag...
