I'm still wrapping my head around the code here.... The channel_start variable, is that an absolute channel? Or just the first channel in that particu...
I have a D1 mini and an UNO sized(D1 R2?) In enclosures with small power supplies. I got a batch of 01's with the weird flash chip, so they are gonna...
Thanks for your reply. I've got a few D1 mini's. They are neat. Also have the UNO version, and a bunch of the ESP01's. I just ordered a bunch of t...
I've been following your progress. I am impressed. I am wondering how many universes you can push out of multiple outputs before any noticable slowdow...
You could always toss in a handful of silica gel pellets. Sent from my XT1254 using Tapatalk
Thankyou
possibly unrelated.... Ive gotten a similar flickering like in the video. I put a resistor between the data pin and ground.
Got Arduino? Where you from? Maybe someone near you has one.
I've been thinking about little presents as controller boxes, also. I'd like to see what yours look like, even though you gave up on them. I was thi...
Vixen 2 has limitations on Port numbers, but you seem to be well under that limit. There could be something conflicting with the Com port on the comp...
Try to use a different wire, atleast for the Data leg. A Pulldown resistor may also help. Some wires(cables) tend to act as a capacitor, not letting...
I inject from both sides. It probably doesn't matter, cause i dont run them at full brightness. If you are using a Teensy 3.2, it supports 8 separate ...
Computer locks up, or the controller? Make sure the computer doesn't turn off certain ports or devices to save power. Sent from my XT1254 using Tapa...
What is the IC on the octo board? A buffer chip to brings the levels up to 5v? That is some amazing speed. I might be buying some of these for next ...
Which teensy is currently the best? I've seen 2.0, 3.1, 3.0 etc.Sent from my XT1254 using Tapatalk
