Somewhere in the sketch, you gotta comment out this sei() command. Seems like there is something else, but it's been years since I've messed with the ...
WLED also seems to work with HA
Take a good look at the spot you cut. There could be a small bit of copper shorting to another. Also check voltage on the end of the strand. It is pro...
Play with the Arduino VU meter project. That would make it respond to sounds directly, instead of waiting for digital commands. You could stand behind...
A Raspberry Pi, or Pi zero would be more suitable for this task. Sent from my XT1254 using Tapatalk
jcasterline wrote:Maybe a 2-stage update could work. 1st upload a minimal placeholder. Not functional as a controller, but just a small gateway allowi...
Maybe a 2-stage update could work. 1st upload a minimal placeholder. Not functional as a controller, but just a small gateway allowing the full versio...
Ok. Looks like redundant data. One should feed the first pixel, the other should be a rollover for the next pixel. Sent from my XT1254 using Tapatal...
If it's the 2801 pixel, one of those is the clock signal. Sent from my XT1254 using Tapatalk
steve123 wrote:I noticed there is a BBB_16 board now that uses the BeagleBone Black instead of the Pocket Beagle. Has anyone done any testing with th...
I used a 3v-5v level shifter, inside heat-shrink tubing. Sent from my XT1254 using Tapatalk
The USB chip might be bogus. Do you have one of those USB programmer dongles? Might be able to use a nano or Uno as a programmer. If you ever manage ...
Manually short gpio0. Sent from my XT1254 using Tapatalk
I've had issues with some of my esp8266 modules when they are too close together. Keep this in mind when deploying this for your show. Sent from my ...
I jumped into vixen with both feet. Long before I bought the F48. I actually used Vixen2 with relays driven from parallel ports. Vixen is what I'm com...
