Earths best practic...
 
Notifications
Clear all

Earths best practice

8 Posts
3 Users
0 Reactions
2,931 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
[#52516]

What's the best practice when dealing with pc power supplies and the multiple negatives?
As per picture I've run each earth from the pc to each component and set of lights. Is this necessary? Or could I either just bundle them all together and join all the negatives to a terminal post, or cut all but one or two and terminate all the light ones together on one negative and run another to a common terminal post for the controllers? I hope that makes sense.

Sent from my YAL-L21 using Tapatalk
Edit: I forgot to mention, I had to transfer everything from a plastic case to this wooden box so it could be painted on the side of the house (under cover so it will never get wet) As the wife thought the other one was 'ugly'.
Also changed word earth to negatives.


7 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Every bit of current that flows through a V+ wire also flows through the V- wire. This statement means combining the V- wires into a single wire will significantly increase the voltage drop on the V- wire. The Earth ground does not carry any current and is there to prevent electrical shock. Please be aware that terminology may be a factor here.: The output of a PSU is V+ and V-. The input to a PSU is AC-Line, AC-Neutral and Earth Ground.


Reply
Posts: 116
(@jcasterline)
Estimable Member
Joined: 15 years ago

I've had issues with some of my esp8266 modules when they are too close together. Keep this in mind when deploying this for your show.

Sent from my XT1254 using Tapatalk


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
MikeKrebs wrote:If you are talking about V- or ground on the dc side of the power supply, I think the last I opened up a pc power supply, all the grounds were internally the same. So they are already connected together. Your particular power supply might be different. They have lots of ground wires to make it easy to connect to different components not because they are all different grounds.

AND to provide sufficient current carrying capacity. A(V+) == A(V-) which means you need as many V- wires as you have V+ wires OR the V- wires need to be sized large enough to handle the aggregate current. It is easier to have an equal number of V+ and V- wires at the same size.


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

Ah, yes. Sorry, sloppy terminology. So based on your reply, I'll run separate negatives. Like I've done basically.


Reply
Page 1 / 2
Share: