ws2812b 'skipper'?
 
Notifications
Clear all

ws2812b 'skipper'?

3 Posts
2 Users
0 Reactions
2,099 Views
Posts: 8
Topic starter
(@gaba-h)
Active Member
Joined: 8 years ago
[#52508]

I was just wondering if there's any type of device out there to almost simulate ws2812b pixels, so that the DOUT is a few pixels later than the DIN. For context, I have a controller in the middle of my setup, with 2 long strands going out on either direction, but I'd like to run each one off of one port. So something that I could also put in the center, that skips the other sides' channels. Maybe there's an arduino application here?


2 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

This sounds like you need a ws28xx receiver that has data in and multiple data out ?
This maybe be done with an Esp32 and i/oexpander .

There is firmware and tutorials for the ws28xx specifically if you google it .


Reply
Posts: 8
Topic starter
(@gaba-h)
Active Member
Joined: 8 years ago
angus40 wrote:This sounds like you need a ws28xx receiver that has data in and multiple data out ?

No I have that, but I’m just curious if there’s a device that could skip channels in the data line. Probably not :/

Sent from my iPhone using Tapatalk


Reply
Share: