blacklightblue wrote:What about adding ATMEGA32U4 or AT90USB1286? They both run have USB and the microcontroller. My friend makes an awesome arduino...
David_AVD wrote: The transmitter side is probably fine. The problem with the regulator on the right is that it will be dropping 19V @ whatever curren...
Yup. Nothing to do with RDM support, but primarily the lack of support for the serial number request message. mrpackethead claimed last year that he...
Most ICs are available in multiple package types. Datasheet indicates WS2801 is available in SOP-14 and DIP-14, however for large-scale OEMs it may a...
You built 1190 of these already? That was fast! Where's your DMX connectivity? I see an address switch, power input, and RGB output, but no DMX I/O...
Hey Pixeltech, got your PM, but I'll respond here since I'd prefer if others can see the discussion and because my PM box is nearly full: My I2C node...
Pixeltech wrote:and it means for my project PIC + SN75176 is better than WS2801 because of distance , and quality , and problems because if one of ...
After reading further - Since your display can be evenly divided into multiple subunits, I would suggest something along these lines: One DMX-to-WS280...
Re: What is Distance Between 2 WS2801 IC ? mrpackethead wrote:The chinese would say that, but the taiwanese would say it was made in taiwan. An...
You may be able to get a replacement iron (e.g. just the iron component, not the entire station) I'm reasonably certain the CSI-1 is just a rebranded...
It's still not entirely clear what you're asking. The WS2801 is a custom dimmer ASIC used for RGB nodes. It is EXTREMELY difficult to obtain bare WS...
I really need to get some 2801 strands. Once I do, I should be able to release a C version of the firmware for this design fairly easily that us mere...
Ideally it would be nice to have more information about what you want to do. I've typically seen "driver" refer primarily to high-power LEDs, because...
I think it was Phil Short (not sure), but he never released anything because he never got it working consistently. Look through the archives in Devel...
Problem is that many RGB LEDs are common cathode or common anode, which makes them a royal pain to drive in a multi-emitter flood (can't do series cha...
