EasyGo
EasyGo
@easygo
Trusted Member
Joined: Jan 4, 2011
Topics: 0 / Replies: 93
Reply
RE: MOUSER EZ-Buy BOMS

daytimer wrote:How about this one . Looking at the data sheets, the only thing different is the way the legs come off it. It still has the same spe...

15 years ago
Reply
RE: MOUSER EZ-Buy BOMS

If you're ordering from Mouser anyway, either of these should work (depending on the quantity, one or the other is cheaper): 512-H11AA1M 512-H11AA1V...

15 years ago
Reply
RE: Triac Question

I've tried more than a dozen different triacs over the last year (with minimum gate currents of 5 mA to 50 mA), and the ONLY one I tried that didn't w...

15 years ago
Forum
Reply
RE: Good old fashioned RELAYS...

n1ist wrote:Actually, the polarization has to do with the magnetics - there's a permanent magnet in there and if your polarity is wrong, the fields wi...

15 years ago
Forum
Reply
RE: Good old fashioned RELAYS...

LabRat wrote:Ahh.. and looking at the standard DCSSR opto, it can push only 50ma, so I would need a small transistor in there as well. (and the diode ...

15 years ago
Forum
Reply
RE: Good old fashioned RELAYS...

And, notice that the coil power of 360 mW / 5 V = 72 mA of operating current ... :omg:

15 years ago
Forum
Reply
RE: Inline SSR

180 ohms is too low... if you use 390 ohms, you'll be getting close to the full 10 mA recommended; however, if you have the status LEDs installed on ...

15 years ago
Forum
Reply
RE: Heatsink Question

If you can bear to wait, you'll be better off installing the triacs after you have the heatsinks. I saw advice from one of the other members within t...

15 years ago
Forum
Reply
RE: RPM - has anyone heard from him?

I tried to contact him in November, and ultimately just went ahead ordered from his web page (a couple of E1.31-to-DMX bridge boards and miscellaneous...

15 years ago
Forum
Reply
RE: How Fast will the 2012 Renard SS Round 1 Group Buy sell out?

OK, I'll be the contrarian: 22 hours, 38 minutes.

15 years ago
Forum
Reply
RE: SSR Random-Phase Turn-on for dummies?

In order to dim with the triac, your controller will have to be aware of when each half-cycle of the 60-Hz power begins (typically done by hardware de...

15 years ago
Forum
Reply
RE: SSR Random-Phase Turn-on for dummies?

They will work fine. Just carry +5 volts to pin 1 on the RJ45, and supply an active-low (ground) signal to turn on the channel (pins 2,4,6,8 on the R...

15 years ago
Forum
Reply
RE: Replacement Triac For Renard SS controllers

CaptKirk wrote:... What about the T410-600W ... The first thing that comes to mind is the dV/dt with open gate is 40 V/uS compared to 400 V/uS with...

15 years ago
Forum
Reply
RE: Low Current Output Design with Power PhotoTriac

CaptKirk wrote:So is this part an alternative? K3020PG ... The K3020PG is just a higher-drive version of the MOC3023 what we're using to drive our ...

15 years ago
Forum
Reply
RE: Low Current Output Design with Power PhotoTriac

I guess I really only have three concerns with driving LEDs. I know it basically works, because I've done it in my living room when testing stuff out...

15 years ago
Forum
Page 4 / 7