nzchristmas.nz wrote:I thought about that. I downloaded it and ran the flash tool, but I couldn't get the NodeMCU into programming mode. If its the b...
mrGrumpy wrote:Isn’t the ESP-1 in the ESPixelStick a 3.3v device The ESPixelStick uses a M74VHC1GT125DT1G as a level shifter.
jchuchla wrote:It's my understanding that the nanostations will only do the auto detection at bootup. So when conditions change, it doesn't automatic...
I use one of these and tap off existing 12v power I have for other lights.
A2K97 wrote:In the description for the pixel spools it says, "There are power injection wires every 50 pixels allowing you to cut your pixels as you n...
DasTrebor wrote:Thanks for the info. I'll keep an eye out after the season is over. Just ordering a basic 4 channel controller and have a couple of st...
mmais68569 wrote:I should have said DCHP address is 192.168.1.2 which is the same as my Show FPP. Did you assign the pi a static address? If you did...
wilkija wrote:FYI - The receiver boards must've gotten hit by a surge or something. I swapped them out and all is well now. You can try replacing t...
jeffu231 wrote:That is not currently possible in a easy sense. You could import the prop into the second preview and then delete the elements it adds ...
Did you change universe size on the ESP? Default size is 512. If you are using 510 in Vixen that would explain your problem.
Coaster wrote:Something I learned when I had some modules that would not work is to use the serial monitor in the Arduino IDE. If you choose baud rate...
Something I learned when I had some modules that would not work is to use the serial monitor in the Arduino IDE. If you choose baud rate of 74880 you ...
