Activity
 
Notifications
Clear all
Coaster
@coaster
Estimable Member
Joined: Dec 15, 2011
Topics: 18 / Replies: 98
Topic
Topic
Forum
Replies: 1
Views: 3563
Reply
RE: ESPixel Pops lagging

CUTTHEMUSIC wrote:I have not. Do you have any links to howto? You can do it from the Nano. After logging use the tools pulldown in the upper right a...

6 years ago
Reply
RE: Flickering Pixels (i.e. bad blinky-flashy)

Just throwing some things out there. It seems like your ESP's are not the problem since they all work fine on the February boards. Things seem to poin...

6 years ago
Reply
RE: Flickering Pixels (i.e. bad blinky-flashy)

angus40 wrote:I see a potential issue. The esp on the left has known issues . Puya memory chip? The only problem that caused was the inability to sa...

6 years ago
Reply
RE: Flickering Pixels (i.e. bad blinky-flashy)

So all of the ESP-01 and 01s work without flicker on the February boards. Do all the ESP's flicker with all the September boards? Is the only differen...

6 years ago
Reply
RE: Flickering Pixels (i.e. bad blinky-flashy)

angus40 wrote:Your component issue may be the pixels them selves . Try using 5v data rather than the questionable 3.xx that the esp-01 is delivering ....

6 years ago
Reply
RE: Bad pixels cause unusual flickering

superdave wrote:Theory.... Could have that one pixel caused enough resistance, that it was limiting how much power was able to get to the 200th? I wo...

6 years ago
Reply
RE: Bad pixels cause unusual flickering

MartinMueller2003 wrote:Each pixel regenerates the signal to all of the pixels after it. If a pixel has gone bad in a way that corrupts the data strea...

6 years ago
Topic
Reply
RE: Problems with a New Prop

How much other Wifi traffic is there around you? Because the ESP runs at 2Ghz there are only 3 channels that can be used. If there is a lot of 2Ghz Wi...

6 years ago
Reply
RE: vixenlights appears to be compromised

I tried it right after this got posted and again right now. No issues for me.

7 years ago
Forum
Reply
RE: Pixelpops/stick wifi module question (esp8266 esp-01)

On the Wemos you actually can supply 3.3v on the 3.3v pin. Make sure you don't have 5v connected too. I have a different project that has a few 3.3v s...

7 years ago
Reply
RE: Pixelpops/stick wifi module question (esp8266 esp-01)

I want to bring up a point that I haven't seen discussed. The ESP/Wemos operate at 3.3v and the outputs are also 3.3v. For reliable operation you need...

7 years ago
Page 2 / 8
Share: