If he is using Static IPs because there is no DCHP function from a router, can he still run multicast? I thought that for no DCHP function then we needed to not run multicast. Am I misunderstanding(again)??
Multicast and DHCP have nothing to do with each other. You can certainly run multicast without DHCP. In fact, you can (in theory) multicast the sACN data to the sticks if they have no address at all, or an invalid address too.
In fact, IP addresses for the device are ONLY used for unicast communication. Think of that in a broader scope than just sending the sACN data though. That's not the only communications a espixelstick does. The HTTP traffic is always unicast. So since you need the web interface of the espixelstick to configure it, it needs to have an IP address (either from DHCP or static) and the sessions between your browser and the stick are always unicast.
A few years ago, the Komby devices were popular. We used the Komby sandwich as a sACN to RF bridge. The configuration for those were hard coded when you compiled and uploaded the program to the board. There was no web page for configuration. When you were using them in multicast mode, they had no IP address at all. These boards performed no communications at all outside of receiving sACN.
CUTTHEMUSIC wrote:I have not. Do you have any links to howto?
You can do it from the Nano. After logging use the tools pulldown in the upper right and chose Site Survey. You get a list of networks around you that the Nano can see. If you sort by strongest signal avoid using those channels. Channels 1, 6 and 11 are the best because they do not overlap.
I downloaded a copy of Acrylic WiFi Pro. I used the Monitor mode and found that the Nano Station has a Retry of 23%(19,000). The retry count of 19000 was steadily climbing. According to Acrylic they say that anything over 10% is bad. I had the Nano channel selection set to Auto mode which selected channel 11. I then switched the nano to use channel 1 and I still had the same retry percentage. I did the same test with only 1 ESP device powered up and had the same results. I avoided using channel 6 because there were a few more networks(including my home network) on that channel and figured it would be the same if not worse. For what its worth my home network (Ubiquity Amplifi HD) currently has a retry value of 33%(2). Im not sure why the percentage is so high but there were only 2 retries. I also did the site survey tool on the nano. There were tons of mac addresses that showed up and I would say about 10 different SSID's. Some of which I recognized as neighbors networks. The furthest away was a house which is about 400 feet away.
From the Acrylic documentation.
Percentage of packets that had to be resent due to a transmission error. The total number of resent packets is shown between brackets.
