Source for ESP modu...
 
Notifications
Clear all

Source for ESP modules

40 Posts
17 Users
0 Reactions
29 K Views
Posts: 9
(@thomashp)
Active Member
Joined: 8 years ago
Coaster wrote:When the ESP starts up it outputs status information on the serial output. What did the output say? On your wireless router do you have 2.4Ghz enabled or just 5Ghz? ESP will not work with the 5Ghz wifi just 2.4Ghz.

Before flashing they did respond to serial commands. After flashing nothing. I tried flashing with the Java took and I compiled the espixelstick code myself. I also tried patch the source file for puya flash chips.

I have 2.4 and 5ghz wifi. No new connectuons.

Sent from my SM-G960U using Tapatalk


Reply
Posts: 9
(@thomashp)
Active Member
Joined: 8 years ago
angus40 wrote:Were they defective ? How could you stand your ground in a dispute ?
Did you try AT commands on them to determine if they worked as designed ?

AT commands worked before flashing, but not after flashing. I would say that these modules are designed to have upgradable firmware. If that is not possible then they are defective. To this is not my first time flashing esp modules. Something was not right with these.

Sent from my SM-G960U using Tapatalk


Reply
Posts: 360
(@jlstout)
Reputable Member
Joined: 16 years ago

I just bought some of these to replace some I had that were doing the same thing. 4 out of 4 work so far.

https://www.amazon.com/gp/product/B01EA3UJJ4/ref=oh_aui_detailpage_o02_s02?ie=UTF8&psc=1


Reply
Posts: 116
(@coaster)
Estimable Member
Joined: 15 years ago

Something I learned when I had some modules that would not work is to use the serial monitor in the Arduino IDE. If you choose baud rate of 74880 you can see the initial output before any installed code runs. You should get something like this.

ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v00000000
~ld

On modules that don't work you may get a chksum error message.


Reply
Posts: 116
(@coaster)
Estimable Member
Joined: 15 years ago
Coaster wrote:Something I learned when I had some modules that would not work is to use the serial monitor in the Arduino IDE. If you choose baud rate of 74880 you can see the initial output before any installed code runs. You should get something like this.

ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
v00000000
~ld

On modules that don't work you may get a chksum error message.

The smiley is actually a colon and "(" don't know how to disable the smiley substitution


Reply
Page 3 / 8
Share: