mrGrumpy wrote:I just had the joy of changing out 10 more of those non puya, no boot flash/memory chips. dirknerkle shared his replacement process of clipping the old chip out, and dealing with a single pin at a time. This keeps from damaging the solder pads. That worked great.....just wish he had a solution for soldering. When I do these SMD components with a soldering iron, I seem to get an onset of shaky-hand until I get the first pin of each chip nailed down.
I work with SMD everyday and does help to have the right tools, especially a microscope (needed for the real small stuff). I also changed out 10 flash chips and the PCB quality on these modules seemed pretty decent to me.
On small SOIC packages like this I typically flood one side with solder then while solder is heated gently lift that side off the pads with an with a X-acto knife. Once one side is lifted touch the other side with iron and chip is off. I always use solder-wick to clean the pads and apply solder to one of the outside pads, then using tweezers place the part and when it looks centered heat the pad with solder on it to get it down and then solder the opposite side corner pad, then solder the rest of the pads. Only issue is if you lift before the solder is heated, then you can mess up the pad. But if you lift gently you can feel the give. I guess it's an experience thing but I have good luck with this technique for years.
Using a small needle point tip and thin (0.15 dia.) Rosen core solder really helps. I saw a video of someone replacing one of these and he basically got solder everywhere and needed solder-wic to unsolder all the pins. You should be able to solder one pine at a time with small tip and thin dia solder with no overflow to adjacent pins. But as long as it works after your done, that's the main thing
Harpster, I do similar to you, except 300 power reading glasses over a 150 power reader = your microscope. Mostly, just the 300 Power.
Heating and lifting with x-acto is what I was doing, but grab a pad in about 1 in 10 - - cutting off and cleaning pad = no pad issues yet.
One trick I should pass along is that I tin the tips of the chip before placing to solder.
dirknerkle wrote:Here's the quick way to repair an ESP module.
I’ve tried that. It works! 😆
I could flash fine and start up. I could go to the web interface and "save" a config. But the config was never saved to flash -- on a reboot or power cycle the ESP would not find its config and thus it could never find the wifi SSID/password and would never come back up baccarat . Acts the same with the java flash tool OR building the source and flashing from the Arduino IDE.
