Network Question
 
Notifications
Clear all

Network Question

41 Posts
9 Users
0 Reactions
9,166 Views
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago
[#49533]

Setting up my GECE ESpixel sticks. Been doing a lot of searching through the forums on what people are doing for a wireless show AP. I bought a TPLink Omada outdoor AP. Have it connected to a standard network switch, no router. My Rasberry PI and laptop are also connected to the network switch. Assigned static IP addresses to the AP, Computer, Rasberry PI, and GECE sticks. Is there any need to be connected to a router connected to the internet?

Reason I'm asking, is I had some issues yesterday with my AP not responding anymore and had to take it down and reprogram. I suspect that I forgot to save any changes and the automatic daily reboot of the AP was turned on to happen at midnight.


40 Replies
kwoodard
Posts: 281
(@kwoodard)
Reputable Member
Joined: 13 years ago

Unless you have a real time clock on the PI, your PI will need to be able to access Internet based NTP servers in order to know the correct time. Without that access, it will not be able to start and stop schedules at the correct time. Now, if you have your PI on both your home network and your show network, your PI can access the NTP time servers from your home network. Other than that, I don't think anything else needs Internet access.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I run my system isolated from the internet…..just need to manually set the time once in a while, because it looses 2-3 seconds a day, otherwise everything is good.

For Switch vs Router . . . I think somewhere in the system you should have a router. I tried a switch too, but the router was a snap.


Reply
Posts: 360
Topic starter
(@jlstout)
Reputable Member
Joined: 16 years ago

So just any old router instead of the switch? What would you need that for if you are not using DHCP?


Reply
Airwolf16
Posts: 101
(@airwolf16)
Estimable Member
Joined: 13 years ago

im just using a AC1200 with 10 ESP's

no need for internet lik eothers have stated, except for the time clocks. i am using a Laptop for the show soooo.

everything is DHCP, multicast


Reply
Page 1 / 9
Share: