rayhjr wrote:I do something similar but with a couple of strips of aluminum. I cut about one inch wide and maybe 8 to 10 inch long pieces of aluminum...
It is good to stay "close to legal". I have been assigned to a FCC contract investigating interference here in Alaska. Cant wait to see the Suburban w...
virgil1 wrote:I do have a printer. Do you have the link on thingiverse? Sent from my iPhone using Tapatalk Yes, this was a design by Wolfie, dont ...
Did'nt like those, but here is a link to a free one that is pretty good. It already has the tree sequenced in x-lights. I added arches and such, and h...
MartinMueller2003 wrote:I agree with everything up to the gnd statement. You need to run heavy gauge V+ and V- from the PSU to your injection points. ...
I 3d printed a case for mine back when I used those. You can also have someone else print it on thingiverse if you dont own a printer. Now I use a Vas...
I just run data only from the PiCap. Run your pixels directly off of the power supply with 15 amp capable wire. I do not run fuses on the pixels. But ...
Pins 1,2, nd 3,6 are the active pins for netork connections. If you look at the pin height from the end you might find one end is higher, pin 8. I ha...
I recently purchased 4 -750 watt hp supply units and need them strictly for power injection units . Looking for ideas on how to enclose them and rig ...
Wilmar, I did have issues with the no hole version with stringing at the top with the .2mm nozzle. So I used the version with the hole that was made f...
I use the glue lined also for exposed splices, pwr inject. It kinda sucks when you have to cut if off though. Have had no issues in rain though.
clpd7 wrote:My computer is wanting to open it with adobe reader. How do I change it to open a rar file? Thanks for sharing the file with me. Now to ju...
I just installed the plugin from the plugin page. Hook it up to your pi via usb cable and go to the Vast Page under input / output setup tab. Here is ...
Just take 16 strings - 2 strings because those will be on the 180 degree line then divide by 180. Or 180 divided by 14= 12.85 degrees. Draw that out, ...
wilmar wrote:Zseam alignment setting will change that you can set to random but my printer didn’t like that so I’m fine with the line . As for threads...
