3D Bethlehem Star
 
Notifications
Clear all

3D Bethlehem Star

36 Posts
23 Users
0 Reactions
25.8 K Views
Mactayl
Posts: 2491
Guest
(@mactayl)
Member
Joined: 17 years ago
Matt_Edwards wrote:I too believe Al TIG welding is hard. Never tried personally as I don't haven't got the right equipment. My brother in-law is OK at at though.

An easier way is Al brazing. It is easy as, even I get good results. I used it to fabricate exhaust pipe for my model boats.

That DuraFix Al brazing stuff looks pretty simple to use, How strong would you say the welds are?


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

Pretty strong. I braze a 450mm Al exhaust on to a manifold for my gas boat. There is a lot of vibrations at 60km/h for a model boat.
if you read the blurb they reckon the alloy is stronger than AL by itself.


Reply
Mactayl
Posts: 2491
Guest
(@mactayl)
Member
Joined: 17 years ago

It's also a heck of a lot cheaper then a MIG or AC/TIG setup for small jobs.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

Thanks Matt. The video on the site is excellent.


Reply
Elmo2resc
Posts: 265
Topic starter
(@elmo2resc)
Reputable Member
Joined: 19 years ago

I use a MIG welder with argon gas. I already had the equipment so the cost wasn't really an issue. It is more difficult to weld though, get it too hot and you have a puddle of metal.


Reply
Posts: 187
(@stevemaris)
Estimable Member
Joined: 16 years ago

Here are a couple of pics of mine.(crappy phone pics, sorry) It is a slight variation of the one above. I used 3/16 steel, and at the bottom, (not pictured) I welded a 4 inch long, 1/2 diameter threaded bolt. I plan on welding a nut to the top of my mega tree pole for it to screw into.

It ended up being 4' 2" tall. I have three channels on it, 2 whites, 1 multi. I channel outer cross, I channel inner cross, and multi's going all around the perimeter. The white minis are all coming off. I am going with cool white leds, and I plan on installing as many as will fit, with minimum 1" spacing.
I ordered the perpendicular light clips so they will all be facing outward.
Hope this helps....
Steve

IMG 9612
IMG 8296 (1) (1)

Reply
Page 4 / 4
Share: