Elmo2resc
Elmo2resc
@elmo2resc
Reputable Member
Joined: Jul 27, 2007
Topics: 33 / Replies: 232
Reply
RE: Arduino's, Vixen3, Fountain project

Good Luck with your Xmas project. You are right around the corner from a couple of us here on DIYC.

12 years ago
Forum
Reply
RE: Controlling servos and motors

ctmal wrote:If you're looking to keep with the Renard protocol(and/or want a diy approach) do a search for renard servo. You could probably find ways...

12 years ago
Forum
Reply
RE: Controlling servos and motors

I have used servo boards in the past for a Halloween show I used to do. I believe they were parallax boards. They were only like $30. Then I just boug...

12 years ago
Forum
Topic
Forum
Replies: 0
Views: 1034
Reply
RE: Replacement Triac For Renard SS controllers

I figured out what was going on with my Renard boards with DMX Firmware. I found an old post that had a suggestion from RavingLunatic. I changed the f...

12 years ago
Forum
Reply
RE: Replacement Triac For Renard SS controllers

I get the issue even on a Renard 64xc with no SSR's plugged in. It is running DMX firmware behind a Lynx Express. The Express doesn't have the issue. ...

12 years ago
Forum
Reply
RE: not geting output past etherdongle in vixen 3.1

Goofytruax wrote:Did you figure out what switch you flipped to get vixen 3 to talk to your controller? I'm having the same issue were it works export...

12 years ago
Reply
RE: Setting up output controllers

I'll try to get it done in the next few days.

12 years ago
Topic
Replies: 3
Views: 1709
Reply
RE: Scrolling pic across a grid

I have done words and defined graphics in the exact res of the grid and it turned out well. In your case 10x30. In my case 18x42. I have made some lar...

12 years ago
Forum
Reply
RE: 2014 MegaTree Pixel/RGB Mounting Strips - Round 1

Elmo2resc wrote:I see you used a 4" Spacing. What is the spacing on your strings? yep your right, my bad. I was afraid 4" spacing would be to tight.

12 years ago
Forum
Reply
RE: 2014 MegaTree Pixel/RGB Mounting Strips - Round 1

I see you used a 4" Spacing. What is the spacing on your strings?

12 years ago
Forum
Reply
RE: Display or Controller Mapping Issue

adski wrote:Yes, the "starts" on the Vixen controller configuration should be: 1 511 730 1240 1630 2140 2482 Dave I also was thinking that.

12 years ago
Reply
RE: Patching Controllers

damo1271, That worked perfectly and much faster. Thanks for the tip, I hope other can us it also.

12 years ago
Reply
RE: Patching Controllers

I will give it a try. That would save some time. Strange way of working but I will take it if it works. Thanks

12 years ago
Page 1 / 18