I need advice on sequencing LED strings. The strings will turn on and dim between 10% and 80% intensity. At 100% intensity the LED strings are off. Is there a way to program all 24 channels to operate within this range? I've tried to use the dimming curve feature but it doesnt seem to do anything. Any solutions would be helpful.
I am using Vixen 2.5.0.8 controling a Ren 24SS.
You can set up the sequence to have a maximim intensity of less than 100% from the Sequence/Settings menu in Vixen. Change the Maximum Intensity to less than 255.
The more important question is why 100% does not work. I don't have a Ren 24SS but use a Ren-C and Grinch combo and this problem comes about if the firmware is not set for PWM dimming which is needed for LEDs.
From the Wiki
Regular Firmware
The firmware can be configured for either PWM or non-PWM operation. By editing the firmware file and changing the #define statements you can select which mode of operation you want.
Non-PWM operation causes a narrow output pulse (30 μS, or so) to turn on the SSRs. This results in the lowest PCB current requirements, because the waveform driving each SSR has a 1:256 duty cycle. The drawbacks of non-PWM operation is that it will not properly control any channel status LEDs (present only on the Renard64 board), and may cause some issues when driving LED strings (e.g. they may possibly not turn on at the upper 25% of the brightness range).
PWM operation sends a variable-width output pulse to turn on the SSRs (the output turns on at a variable time in the AC power cycle, and stays on until the end of the cycle). This presents a PWM signal to any attached channel status LEDs, causing them to have a variable brightness that somewhat corresponds to the brightness of lamps attached to the SSRs. It will also be better at driving LED strings on the output of the SSR (because the PIC drives the SSRs throughout the cycle, rather than relying on the current through the opto-isolator to latch the opto).
Jon
Deleted - better answer above. We both typed at the same time.
I'll reflash my PICS and see if that helps. Thanks
Timely topic and I'm interested to see how it goes for you.
Today while checking on my renard 64 / dirkcheap.
I found the same thing. I did stumble on the intensity setting and that did work to get the LEDs mostly on.
I was also seeing that ramps and fades in vixen worked while setting to 100% on was ignored. Turning the setting for max down from 255 fixed that but the lights weren't as bright as they could be.
Hopefully the pic flashing will help.
komby wrote:
Hopefully the pic flashing will help.
Well I took a few min this AM and reflashed the PICs with PWM and it fixes this issue and its AWESOME!
I had thought I had an issue with my 64 board and it turned out I did 🙂 I was running the wrong firmware! After update all my LEDs on board are working and 100% is working on all of my Lowes, Walmart, and BigLots strings!
Thanks again!
