Rg 58 question
 
Notifications
Clear all

Rg 58 question

8 Posts
5 Users
0 Reactions
2,660 Views
Posts: 947
Topic starter
(@warlock)
Noble Member
Joined: 19 years ago
[#19706]

Would it be alright (since I live in an apartment building) to use rg-58 coax cable as my ant for the season...I do not need the signal to go any further then about 200 feet at max so distance is not of importance to me.Clear signal is important...
Thanks for the help.
Joe...

P.S. If this would work what length would work best ????
Thanks again.
Joe...


7 Replies
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

RG-58 should be fine. Wait a sec, are you talking about using it as the antenna, or as the feedline to the antenna?


Reply
Posts: 947
Topic starter
(@warlock)
Noble Member
Joined: 19 years ago

Using it as the antenna...Or if not could I use a small set of rabbit ears etc ???


Reply
Posts: 95
(@cessnapilot)
Trusted Member
Joined: 18 years ago

This is what I used to make a dipole antenna. I stripped back about 2.5 feet of the outer insulation and then pulled the inner insulation and center conductor out of the braided shield. The shield is one side and the center conductor is the oher side.


Reply
glaforce
Posts: 414
(@glaforce)
Honorable Member
Joined: 17 years ago

Making a dipole antenna out of RG-58 works great I have made lots of antenna this way from 28.000 MHz all the way up to 900 MHz and they work just fine. This also how I made my fm02 antenna but I encased it in 1/2" PVC pipe to act as a raydom to protect the antenna and it makes it much easter to install outside. With this antenna mounted only at about 6' high off the ground I cover about 3 blocks around my house which is way more then one needs. If you need any help just post or pm we will be glad to help you get it figured out.

Gary

Sent from my Inspire 4G using Tapatalk 2


Reply
IdunBenhad
Posts: 1603
(@idunbenhad)
Noble Member
Joined: 18 years ago

Hi:
RG-58 is fine.
Look at "FM02 Transmitter Setup" in this forum to see how to make it as Cessnapilot described.

I would not use the rabbit ears unless they are fed with coax. The impedance will be too far off for the transmitter.


Reply
Posts: 947
Topic starter
(@warlock)
Noble Member
Joined: 19 years ago

Sounds great to me...How would one do this or is it posted on the site someplace ???


Reply
IdunBenhad
Posts: 1603
(@idunbenhad)
Noble Member
Joined: 18 years ago

Hi:
It's right here in the "Radio Waves" forum. Just look down the listing.

If all else fails: http://doityourselfchristmas.com/forums/showthread.php?12895-FM02-Transmitter-Setup


Reply
Share: