Pvc window frame
 
Notifications
Clear all

Pvc window frame

26 Posts
15 Users
0 Reactions
13.5 K Views
Posts: 172
Topic starter
(@rooster519)
Reputable Member
Joined: 11 years ago
[#43155]

I'm wanting to build my window frames from pvc. They will be roughly 6' wide by 4' tall. My question is when assembling these should I glue the joints or not? The concern comes with storage being that large, but if I don't glue them will they slide apart over the winter? I'm sure someone has dealt with this before


25 Replies
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

I glue and store in my shed.


Reply
Posts: 141
(@jspiker77)
Estimable Member
Joined: 11 years ago

I do not glue mine, I take them apart and fold them up for storage, have never had them come apart during the show season.


Reply
Posts: 123
(@tonyhight)
Estimable Member
Joined: 12 years ago
jspiker77 wrote:I do not glue mine, I take them apart and fold them up for storage, have never had them come apart during the show season.

Same here

Sent from my SM-G935V using Tapatalk


Reply
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago
tonyhight wrote:Same here

Sent from my SM-G935V using Tapatalk

If you are worried about them coming apart then put a screw into the joints.

Sent from my iPhone using Tapatalk


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

They are pretty tight when you put them together. I would be surprised if anything moved on you...


Reply
Posts: 843
(@captainmurdoch)
Prominent Member
Joined: 14 years ago

I glue and use Boscoyo strips to mount the lights. Glue also helps keep the frame from going out of shape when handling. I have some 4 foot wide windows so I used 3/4" PVC instead of half inch. Two screw eyes on top of each frame and two matching "ceiling hooks" on the house to hang the frame on. Then another single cup hook on the bottom of the frame and matching one on house. I put a zip tie around the two cup hooks at the bottom to hold the frame from blowing in the wind any. In the garage I have a set of 2x4's with cup hooks on the bottom of them so I can hang all the window frames together using the same screw eyes that they mount to the house with.


Reply
Posts: 911
(@madsci1016)
Noble Member
Joined: 12 years ago
jspiker77 wrote:I do not glue mine, I take them apart and fold them up for storage, have never had them come apart during the show season.

Also same! And my hang from the eves and I have bigger windows 5' by 5'. I do have Bosco Pixabulb strips on them so that 'could' provides some hold too but I doubt it. It's probably all just jaming together every year.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Depending on how you plan to support the horizontal pieces, you might consider using EMT, as PVC will sag in the middle if it is not supported there also.


Reply
dgirard
Posts: 337
(@dgirard)
Reputable Member
Joined: 17 years ago

If you use EMT, what do you use to join the corners? All the 90 degree EMT fittings I've found have been a bit pricey compared to PVC...or does it fit in the PVC fittings?


Reply
Page 1 / 3
Share: