mixing stranded and...
 
Notifications
Clear all

mixing stranded and solid wire

8 Posts
6 Users
0 Reactions
10.1 K Views
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago
Amino wrote:its 12V DC. I'm planning on soldering with heat shrink and then covering all that with liquid electrical tape. So it sounds like it should be OK?

Hi, soldering would be my choice it's not good to crimp solid cable.


Reply
Posts: 99
(@sulrich)
Estimable Member
Joined: 13 years ago

when i solder, i use shrink tube for each of the 3 wires, then a thicker marine grade tubing to encompas that..i start to shring with the heat gun in the middle and work towards the edges, at about 3/4" away from each end i stop. I use a small injection of gorilla hot glue in each end. then finish the shrinking. it will ooz out the ends but that is as water tight as a dolphins a**..


Reply
Posts: 631
(@stampedeboss)
Honorable Member
Joined: 13 years ago

Be careful, copper vs copper clad aluminum (CCA); I made the mistake of using cca with copper. I had to replace every lead and plug in my display this year due to exposed aluminum being exposed during cutting and soldering and dissimilar materials will corrode. I ended up having to discard over 50% of my 3 core connectors since they would no longer take solder.

Sent from my iPad using Tapatalk


Reply
Page 2 / 2
Share: