mixing stranded and...
 
Notifications
Clear all

mixing stranded and solid wire

8 Posts
6 Users
0 Reactions
10.1 K Views
Posts: 6
Topic starter
(@amino)
Active Member
Joined: 9 years ago
[#47540]

Is there an inherent danger of combing solid and stranded copper wire? I've got outdoor solid copper wire and I need to use pigtails that are stranded copper in order to hook it up. What's the best way to connect them? Solder them like I would with a stranded-stranded connection?


7 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

don't cross the streams!
Just kidding. No there's no problem at all mixing them. The only wires you don't want to mix is copper and aluminum. Soldering is typically much more difficult with solid wire, especially of a large gauge. Mechanical connections are typically easier and just as reliable.


Reply
Posts: 464
(@holtm)
Honorable Member
Joined: 19 years ago

What voltage? AC/DC? Are the connections going to be in a weather resistant enclosure?
For low voltage, not in an enclosure, solder and adhesive lined heat shrink is the way to go I think.


Reply
Posts: 6
Topic starter
(@amino)
Active Member
Joined: 9 years ago

its 12V DC. I'm planning on soldering with heat shrink and then covering all that with liquid electrical tape. So it sounds like it should be OK?


Reply
Posts: 464
(@holtm)
Honorable Member
Joined: 19 years ago

Yes, and the liquid tape maybe overkill.


Reply
Page 1 / 2
Share: