Hi,
Will LED's that can run on 240V also run at 24V without any modification?
Thanks, FJ
Hi FJ, usually any LED Strings in Aussie are reduced to 24V.normally they have a transformer to reduce to 24V otherwise they are illegal to use outdoors.Wether they are AC or DC is another thing though.If they are running AC they will sometimes have a flicker.
G
If you mean LED strings that are direct connect (no transformer), then the answer is no. The 240V ones are arranged in one big series string (80 LEDs?) I believe. The 24V ones are in a series / parallel arrangement to suit the much lower voltage.
You could certainly cut and rewire sections to suit the 24V system. I think the 240V versions we get over here are almost all indoor use only. Whether that's purely because of the high voltage or due to the lesser weatherproofing I don't know.
the string is 100 count LED that connects direct to 240V, no transformer, just a controller box for the typical 8 different functions (fading chasing etc.)
the string was advertised as outdoor suitable.
on the string the first three LED's have no resistors, the next 15 have resistors, then the rest of the string doesn't. the resistors have bands on them - orange, black, red, gold - in that order. there are four wires coming from the controller to the LED string.
is it possible that those resistors are cutting down the voltage to 24V anyway?
Sounds like a chinese string, i had a few of them saying they were ok for outdoors...never used them...and to cut down to 24V the resistors would be at a very high ohms for chasing anyway
the wizard says
LED series/parallel array wizard
The LED series/parallel array wizard is a calculator that will help you design large arrays of LEDs. The LED calculator was great for single LEDs--but when you have several, the wizard will help you arrange them in a series or combined series/parallel configuration. The wizard determines the current limiting resistor value for each portion of the array and calculates power consumed. All you need to know are the specs of your LEDs and how many you'd like to use.
240 Source voltage
2.5 diode forward voltage
20 diode forward current (mA)
100 number of LEDs in your array
View output as: ASCII schematic wiring diagram
The wizard thinks your source voltage is too high to be practical.
you are right, they are chinese LED's.
and if i got the resistor colours right, they are very high 3K ohms, as you suggested.
looks like i need to keep searching for a good source of LED's to use for 2010 !
thanks for the help.
I think someone posted on one of the lists about some of the really cheap 240V (220V) Chinese LED sets. From memory they were really dodgy and almost a fire risk. Converting them to 24Vdc may be the best thing to do!
If its like the ones I got off tradme here in nz a while back - they are specifially prohibited items, yet all the importers for the 2 dollar shops still keep bringing them in - read here = http://www.energysafety.govt.nz/templates/MultipageDocumentTOC____23839.aspx - basically the supply cable is too thin (should be 0.75mm² minimum) only thin insulation on them (can push thru it with fingernails) and the wires will just fall out of the controller board since they are barely attached.
The resistors are spread out because that means that none are disipating too much power for their wattage rateing, and the red ones need more resistance so will have a few more.
They claim outdoor on the ones I had a year or so back, so I put them up outdoors and they lasted ok.
