electronics enclosu...
 
Notifications
Clear all

electronics enclosure

10 Posts
7 Users
0 Reactions
3,317 Views
Posts: 295
Topic starter
(@daytimer)
Reputable Member
Joined: 15 years ago
[#27674]

Is anybody using a simple rubbermaid type bin to hold their electronics outdoors?
I have a front porch I can tuck things under and I am thinking of using a large plastic box, upside down with holes for ventilation to house the 5vdc power supply, e682 and ren64.
Thoughts? Pictures of yours?

Thanks!


9 Replies
Posts: 50
(@vegaslight)
Trusted Member
Joined: 14 years ago

I use small Rubbermaid containers that latch to hold a miniren 8xblsd and 12v 3.2 amp power supply. Works great, all power enters the side (which is the bottom when installed and I use 2mm double side tape (used for cell phone screens as a gasket on the lid. While not water proof, it is certainly a great water resistant solution.. no moisture in side at all


Reply
Posts: 295
Topic starter
(@daytimer)
Reputable Member
Joined: 15 years ago

That's good to hear. I was worried about condensation. But, I will leave vents in it too. It will be tucked up under my porch so that will help give it even more protection from the elements.
I am still interested if anybody has any pics of their outdoor electronics enclosures.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

I use a couple of battery boxes. I know Dave (Dirk) has used them too. They are nice because they have wire runs. Just have to seal the vents on top.

106205

Reply
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

I am using Hefty storage boxes in covered areas. This is from my Halloween setup.

2013 11 05 14.35.30
2013 11 05 14.35.53
2013 11 05 14.36.05
2013 11 05 14.36.14

Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I used an ordinary container with a double dose of garbage bags to house my power supplies and switch for my E681's (disregard the broken topper laying on it - - - long story...).

I will be using Dribox'sthis year though - no more bagging...


Reply
Posts: 295
Topic starter
(@daytimer)
Reputable Member
Joined: 15 years ago

Thanks for the responses and especially the pics! I was worried about condensation especially with the power supply and ic's on the 682. But, I did figure on leaving a vent hole on the bottom to help.
Glad it can easily be done that simple!


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

I bought a few controllers from a guy that used small rubber maid boxes for Renard 24 HCs. Here are a few pictures:

DSC07744
DSC07745

I do not remember if he said how long they were used or if he put them under anything or wrapped in a bag. The controllers still work though!


Reply
Posts: 295
Topic starter
(@daytimer)
Reputable Member
Joined: 15 years ago

Thanks all for the ideas and pics.
We'll see how this works! I attached a piece of foam to the lid to help seal it up a bit. Even though this will be tucked under the porch, I don't want the chance of snow blowing in.
Ren64, FM02, E682, 5V PS


Reply
griffixdc
Posts: 2512
(@griffixdc)
Famed Member
Joined: 16 years ago

you gots todo what you gots todo, to save money , so you can buy more blinky flashy.


Reply
Share: