dual switch questio...
 
Notifications
Clear all

dual switch question

8 Posts
5 Users
0 Reactions
3,239 Views
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago
[#11864]

I'm trying to get all my backlogged projects completed, I'm running into a snag with one of them.

I have 2 momentary buttons, each will trigger its own circuit to run.

What I am hung up on is this;

Button One needs to trigger circuit one and kill power on circuit two.
Button Two needs to trigger circuit two and kill power on circuit one.

Any suggestions?


7 Replies
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

Sounds like a Set / Reset flip flop, using the Q and Q-bar outputs. Should be circuit examples out there using either transistors, relays or ICs.


Reply
klanger
Posts: 739
(@klanger)
Prominent Member
Joined: 20 years ago
David_AVD wrote:Sounds like a Set / Reset flip flop, using the Q and Q-bar outputs. Should be circuit examples out there using either transistors, relays or ICs.

I'll say it for you Steve,, huh??:rolleyes:


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

Basically, you’re trying to set up two DPDT switches. Each side of the switch does a separate function. The power is connected to NC on one side and when you push the switch, those contacts open. On the other side your trigger is connected to the NO contacts so when you push the button, the contacts close and trigger your circuit.

This function can be totally contained in the switch or you can use the switch to control a relay or a logic circuit.

Do an internet search and you should be able to find examples. If not, let us know.


Reply
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago

Correct Ernie,

The only additional function is to de-energize the capacitors on the powered down half of the circuit.

I am bread-boarding this circuit to see if I can hammer it into what I need. Don't need the relay just the triggering signal.

A 2 button device that will trigger one of two audio playback units, while one unit is playing the other unit needs to de-energize its own power capacitor to prevent both units from playing at the same time if you tap both buttons. Perhaps a time delay with a 555 to ensure the caps have enough time to drain before it will allow a re-trigger.

This is an old project thats been gathering dust and I want it completed.


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago
Aurbo99 wrote:Don't need the relay just the triggering signal.

As a sign of the times, you could that with just two PB’s and a PIC10.:)


Reply
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago

Your absolutely right Ernie..

I could do that too.. just never really tinkered with it enough to work one out..

Goes to show I still think mainly in analogue..


Reply
Posts: 485
(@sjwilson122)
Honorable Member
Joined: 19 years ago

You and me both Steve. I was sitting here drawing out a circuit using two SPDT self latching relays, using the P/B as basically an interupt. I guess it's time to start moving into the digital world..................


Reply
Share: