WS2811 strip issue
 
Notifications
Clear all

WS2811 strip issue

3 Posts
2 Users
0 Reactions
1,408 Views
Posts: 79
Topic starter
(@slim00209)
Estimable Member
Joined: 13 years ago
[#45664]

I having an issue with 12v 30 LED/M WS2811 strips used in HDPE arches. They are cut into 69 LED, 23 IC lengths, hooked to a Falcon F16v2. The problem that I am having is that I cannot get them to work when daisy chained together. For example, if I plug arch 1 and arch 2 directly into the controller on separate pigtails, they both work. If I plug arch 1 directly into the controller, and arch 2 into arch 1, arch 1 works but not 2. Multi meter test show that I am getting 11.8V at the end of arch 1. I have checked and rechecked my data connection at the end, and it is solid as well. I have tried testing in both Falcon test mode via the test button as well as accessing the controller by IP. When accessing the controller, the string port is set to enough lights for the two arches on the output. I am about to 1. Abandon the HDPE and go with Boscoyo arches or 2. Run the arches off of 1 output each. Any insight that you might have would be helpful at this point.

Thank you,

Sent from my iPhone using Tapatalk


2 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

It sounds to me like there's something wrong with the output pigtail on arch 1.
Is your arch 2 set up the same as arch 1 with an output pigtail? Try switching arch 1 and 2 and see if it works. If it does. You know you have something wrong with the output pigtail.

I'd look for shorts in the output pigtail wiring. It's very easy to get a short when you're putting on the pigtails. It's likely ground to data short since you're not damaging anything by shorting power across data.

Sent from my iPhone using Tapatalk


Reply
Posts: 79
Topic starter
(@slim00209)
Estimable Member
Joined: 13 years ago
jchuchla wrote:It sounds to me like there's something wrong with the output pigtail on arch 1.
Is your arch 2 set up the same as arch 1 with an output pigtail? Try switching arch 1 and 2 and see if it works. If it does. You know you have something wrong with the output pigtail.

I'd look for shorts in the output pigtail wiring. It's very easy to get a short when you're putting on the pigtails. It's likely ground to data short since you're not damaging anything by shorting power across data.

Sent from my iPhone using Tapatalk

I'll give that a try. Thanks you.

Sent from my iPhone using Tapatalk


Reply
Share: