Configuring 2 Alpha...
 
Notifications
Clear all

Configuring 2 Alphapix 16 controllers

14 Posts
7 Users
0 Reactions
8,891 Views
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago
[#45652]

Hello all,
I recently purchased two alphapix 16 controllers from holiday coro. My intentions are to use both controllers for a mega tree with 16 strings of pixels (50 nodes on each string).
I am new to using this type of controllers and have been watching a ton of videos and asking questions of holidaycoro (I don't want to wear out my welcome with them.
Right now I am trying to configure the web interface for both controllers (which I am going to hook up via a switch to my PC).

I am trying to get it set up correctly and will eventually be using xlights. After watching holidaycoro's videos this is what I came up with to enter for the Pc configuration.

Can any one offer input or advise if I am on the right track.
Thank you in advance for any help

IMG 0333

13 Replies
Posts: 1344
(@mrsmoofy)
Noble Member
Joined: 12 years ago

Is there a reason you're limiting yourself to just 50 pixels per output? Each output supports 340 pixels you could run the entire tree on 3 outputs of one board.


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

Until you start using xlights I'm not sure there is much point. These controllers, and eventually xlights, will need to be setup the same as far as universes go.

Sent from my Pixel using Tapatalk


Reply
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago

I am using it with the 50 pixels per out out because that is the way it was set up when I bought it. I am very new to this so I bought one of the kits from holidaycoro, but It was set up for 180 degrees. I bought 2 kits in order to do a full tree. I will eventually, when I expand, set it up differently. I am just trying to get an grasp on pixels and controlling them.

Phrog- I am aware of that too. But I think the was the web interface and x lights sets up are a little different. If I understand it correctly I will have to address xlights in a way that each output is designated by what node # it is. I think it will go something like: output 1 pixels 1-150, output 2 pixels 151-300, output 3 pixels 301-450, etc. if I understand it correctly


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

Wow, you could do a 360 degree tree with a 4 output controller. Feel free to do whatever you like, but using two 16 output controllers for one tree is really wasteful. Have you watched this video,
http://www.holidaycoro.com/kb_results.asp?ID=118 .

The hardest and most time consuming part to this hobby is sequencing and you can do that without any hardware. My advice, dig into xlights first and then the rest will make more sense.

Tons of videos at xlights.org.

Sent from my Pixel using Tapatalk


Reply
Page 1 / 3
Share: