vwbugjpt wrote:FYI, the Alphapix 16 controllers are rated output to support only 340 pixels per channel but using xlights I've been able get each Alphapix 16 channels to address 510 pixels or 170 nodes using 12v bullet nodes and the intensity set at 50% or less.
There is a lot wrong with what you posted. A pixel and a node is essentially the same thing, at least in RGB. Probably what you mean is you used 170 pixels which is 510 channels. Turning down the brightness will not allow you to go past the physical pixel limit of the controller. It may prevent the need for power injection. It sounds like the op is new so we don't want to muddy the waters anymore than they are.
Sent from my Pixel using Tapatalk
heffyone wrote:Hello all,
I recently purchased two alphapix 16 controllers from holiday coro. My intentions are to use both controllers for a mega tree with 16 strings of pixels (50 nodes on each string).
This may help as it describes how to setup xlights and LOR for use with a 16 x 50 pixel setup:
http://www.holidaycoro.com/product-p/841.htm
and then your second controller, you need to change IP address (eg 192.168.0.60) and set DMX start universe 17 to 32 (as per your original thought) and then add E1.31 as per HC diagram but changed as required (see pic)
Note: newer version of xlights (currently 2017.21) has extra box in the E1.31 setup, you can now add a description
Thank you for all the great help. The summer has been crazy. I'm going to get this up and running in a couple of weeks when the kids start school again.

