Trouble shooting E6...
 
Notifications
Clear all

Trouble shooting E682

24 Posts
9 Users
0 Reactions
6,330 Views
Posts: 686
Topic starter
(@traneman)
Prominent Member
Joined: 16 years ago
[#32422]

Here is my problem.
Cluster 1 works fine it is RGB,Cluster 2 and 3 are BRG using test patterns 1,2,and 3.

I have swapped ic's and nothing changed.

Any ideas on what to test would be great.

Thanks

Here is my setup

E682

23 Replies
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

i don't know if it is the problem but your universes are overlapping


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Also not part of the issue - but is there a reason you're not assigning it an IP address? If you give it an IP you can use Unicast and get all 12 universe available to you.


Reply
Posts: 686
Topic starter
(@traneman)
Prominent Member
Joined: 16 years ago

Just dont need the extra universes now


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

your rgb config does not show BRG . What is your exact issue ?


Reply
XmasInGalt
Posts: 526
(@xmasingalt)
Honorable Member
Joined: 19 years ago

It looks like all four groups are RGB not RGB for cluster 1 and BRG for 2 & 3.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
XmasInGalt wrote:It looks like all four groups are RGB not RGB for cluster 1 and BRG for 2 & 3.

OK - you have them set for RGB but the light output is BRG - is that correct? If so, just change the setting to BRG and it should follow RGB format (channel 1 = Red, channel 2 = Green, channel 3 = Blue)


Reply
Posts: 686
Topic starter
(@traneman)
Prominent Member
Joined: 16 years ago

I want them to be all rgb like I have them setup on the controller.But only cluster 1 is rgb the rest are brg on physical lights.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

if the physical is BRG select this in your e68x config and they will be rgb . your actual lights color order will be revealed to you using test patt 1 , 2 , 3


Reply
Posts: 686
Topic starter
(@traneman)
Prominent Member
Joined: 16 years ago

Ok I guess Iam not explaining what is happening right.
I have the controller set up rgb for all 4 clusters,but what Iam getting on the actual lights is.
Cluster 1 rgb
2,3 and 4 brg. All the lights have the same chip.

Hope thats better to understand
Thanks


Reply
Page 1 / 3
Share: