Testing pixel stick...
 
Notifications
Clear all

Testing pixel stick controller using xlights output to pixel

9 Posts
3 Users
0 Reactions
3,731 Views
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
[#47098]

I'm testing a pixel pop tiny controller using xlights program.

I've used xlights before in my show with out any problems. this is first season using Pixelstick controllers. I have been messing with this a good while now. In test mode it is taking approximately 5 to 6 seconds for the output to the pixel to start or turn on and the same time to turn off, plus the color doesn't represent the color that I tell it to submit. In sequence mode the timing is off that much all the way through. The transistion fade in and out are set at zero.
I originally thought the pixel stick wasn't working right. Now I think it is in xlights.
When I do the test mode directly from the pixel stick web page it works instantaneously with correct color.


8 Replies
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
MikeKrebs wrote:xlights config? uni or multi?

sporadic upgraded the software to "released" recently. have you upgraded?

access point make and model?

It is set to Multicast.

I figured out that it isn't Xlights.

Xlights runs fine with Sandevice.

I can't figure out what is happening with Pixelstick and the delay turning the pixels on. I have been on it for a few days now and I'm testing one at a time and so far I haven't got the first one to work without the delay in tuning a pixel on. I have not upgraded to the last version. I haven't seen any post about others having a delay in turning pixels on.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
MikeKrebs wrote:it's a long time to have a buffer problem. your computer is connected wired to access point?

some low end routers don't know multicast.

Router is Cisco Linksys E1200. I haven't had a problem with Sandevices using these routers.
I have a few of these and tried another and get a delay in turning pixel on.
Retrack from first post about the color. The color selected is what is lit up. My error in stating that it wasn't .


Reply
kwoodard
Posts: 281
(@kwoodard)
Reputable Member
Joined: 13 years ago

Make sure your computer is directly wired to the access point. Sending data from xLights over wifi and also to the Pixel Sticks will cause problems. Are you multicasting a lot of data? I've found that if the ESP8266 has to processes a lot of incoming multicast data, it can bog down. I would be tempted to try unicast to the wireless device and see if that improves things.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
kwoodard wrote:Make sure your computer is directly wired to the access point. Sending data from xLights over wifi and also to the Pixel Sticks will cause problems. Are you multicasting a lot of data? I've found that if the ESP8266 has to processes a lot of incoming multicast data, it can bog down. I would be tempted to try unicast to the wireless device and see if that improves things.

The computer is wired to the router, if that is what you are calling the access point. The router is by it's self, and not on any network.

The sequence from Xlights is bare minimum data. One model with 2.5 seconds of red. When the cursor passes the start of red, the pixel does not turn red until six seconds later. And when the cursor passes the end of the red, the pixel turns off six seconds later.

Maybe it is the quality of the ESP8266 that I'm using.


Reply
Page 1 / 2
Share: