Good day all. Newbie here so please excuse the ignorance.
Just purchased a PixLite 4 and intend to drive my show using Falcon Player on a Raspberry Pi. So far all seems to be going well but I've run into a little snag. My intent is to keep the show network separate from my home network. I'll be using the RP3's WiFi interface to connect to the home network and the ETH0 interface connected directly via Cat5e to the PixLite controller. I've enabled the routing option in the FP Network settings but so far I've been unable to access the PixLite from a computer in my home network. If I SSH to the RP I can ping the IP of the PL controller. I can (obviously) ping the RP from my computer. I believe the issue to be the lack of a default gateway setting on the PL controller. I've tried looking at it's web interface and through the settings on the controller's LCD.
Here's my network set up:
Home Network
IP Range - 10.0.0.x-10.0.3.x
Netmask - 255.255.252.0
Gateway - 10.0.0.1
Raspberry Pi (WLAN0)
IP - 10.0.1.5
Netmask - 255.255.252.0
Gateway - 10.0.0.1
DNS - 10.0.0.1, 8.8.8.8
Show Network
IP Range - 192.168.1.x
Netmask - 255.255.255.0
Gateway - 192.168.1.5
Raspberry Pi (ETH0)
IP - 192.168.1.5
Netmask - 255.255.255.0
Gateway - blank
DNS - 10.0.0.1, 8.8.8.8
PixLite 4 Controller
IP - 192.168.1.50
Netmask - 255.255.255.0
Gateway - ??? <--- Can't figure out where to set this.
Was wondering if anyone encountered similar issues w/ the PL controller?
I have a pixlite4 and it does not have a gateway setting.
Due to the way I have my show network setup, I cannot access the admin of the pixlite controller from my home network. It needs the gateway setting to know where to reply to the packets. All my other controllers I can access because they have the gateway setting in their configurations. Internal to the show network, the Pixlite responds to HTTP requests and functions normally, it just will not respond to routed packets.
mildog wrote:I have a pixlite4 and it does not have a gateway setting.
Due to the way I have my show network setup, I cannot access the admin of the pixlite controller from my home network. It needs the gateway setting to know where to reply to the packets. All my other controllers I can access because they have the gateway setting in their configurations. Internal to the show network, the Pixlite responds to HTTP requests and functions normally, it just will not respond to routed packets.
Thanks for confirming mildog. I was afraid that was going to be the case and wish now that I'd thought about it BEFORE I bought the PixLite controller...:blush2:
Hi Mike,
Thanks for the suggestion. That's what the routing 'checkbox' enables on the Pi. However, the PixLite has no (apparent) ability to configure a default gateway. Without a default gateway, there's no way for the PixLite to communicate with any devices not on the show network.
Before I bricked my Advatek controller a year ago, I seem to recall that I had to use their "assistant" tool to configure the network settings rather than doing it through the web UI. Is that still the case?
You can also email the guts at Advatek. I've found them to be fairly responsive, albeit with time zone differentials.
