Notifications
Clear all

Test Sequence

8 Posts
4 Users
0 Reactions
2,875 Views
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

depends on which controller you have some of them have test feature built right in if not I setup xlights really fast and use the test function that it has

T4Z wrote:Glad I was on the right track! I run every new strip or string for 12 hours. After I have built an element with them I test them again for another 6 hours or more. The mini controller and a pc power supply make a really simple and compact test setup. I usually just use the white meteor effect so that all the leds get a good run-in and any fauly ones are easy to spot.
Cheers. Taz.

Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

I find the colorwash cycling red,green , blue to be best test pattern. Xlights or falcon boards have this test. Not only finds dead nodes also shows those nodes where there is a weak signal. Suppose u have a node where red and green are fine but blue is half bright at 255 as compared to other nodes. Colorwash clearly will show this bad node

Sent from my iPhone using Tapatalk


Reply
Posts: 172
Topic starter
(@rooster519)
Reputable Member
Joined: 11 years ago

Makes a lot of sense. I think I'll just set the computer up in the basement and let it run all night for each strand of lights. Then I can check them in the morning. It will at least get things moving forward until more parts come in. Thanks a lot!!!


Reply
Page 2 / 2
Share: