Question on 12v 281...
 
Notifications
Clear all

Question on 12v 2811 pixels

23 Posts
10 Users
0 Reactions
5,772 Views
Posts: 326
Topic starter
(@robertb)
Reputable Member
Joined: 17 years ago
[#42036]

How much past 12v can I run these? Can I run these at 13v ok? Just want to get just a little bit more juice at the ends of the run.


22 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

There have been several reports of problems whenever some WS2811 nodes were pushed past the 12v mark.
A common fix for these situations has been to back the voltage down to below 12 volts (e.g., 11.9vdc).
I'm not sure what your particular lights will tolerate.


Reply
Posts: 326
Topic starter
(@robertb)
Reputable Member
Joined: 17 years ago

Huh. Below? Never heard that. Since I'll be playing with the power levels anyway... I'll give that a try. However with the long runs I am running, already getting some drop in voltage and thought this is what was causing some flickering.

algerdes wrote:There have been several reports of problems whenever some WS2811 nodes were pushed past the 12v mark.
A common fix for these situations has been to back the voltage down to below 12 volts (e.g., 11.9vdc).
I'm not sure what your particular lights will tolerate.

Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Look through the threads. There are plenty of times this has come up.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

It's because the pixels are really 5V. They reduce the voltages at the pixels....which is why over voltage can damage the pixel. Undervoltage can totally work depending on the string lengths. If you need the extra juice....power inject or run 24v with buck convertors.


Reply
Page 1 / 5
Share: