Technicolor quality...
 
Notifications
Clear all

Technicolor quality?

256 Posts
45 Users
0 Reactions
83.4 K Views
Posts: 95
(@danolgb)
Estimable Member
Joined: 17 years ago
timon wrote:Disney Technical nirvana.

I'll ask around and see if there are any plans for this year. If I find out details, I'll post in a new thread in the lounge.


Reply
Posts: 853
(@roterhead)
Prominent Member
Joined: 15 years ago
danolgb wrote:I'll ask around and see if there are any plans for this year. If I find out details, I'll post in a new thread in the lounge.

Thanks! I'd be interested in attending....


Reply
Posts: 419
(@txag2008)
Honorable Member
Joined: 17 years ago
I suggest outside real world testing in rain while weather is still cold for more realistic testing after indoor testing is done.

This.


Reply
dsmjuggalo
Posts: 663
(@dsmjuggalo)
Prominent Member
Joined: 15 years ago

How about a test with some extreme on and off flashing. Like full brightness to off.


Reply
Posts: 23
(@hauvega)
Eminent Member
Joined: 18 years ago

Looking for a status update on the prototype testing.


Reply
Posts: 13
(@gavspac)
Eminent Member
Joined: 15 years ago

I've just received some replacement technicolor pixels from Ray which are apparently redesigned with a larger board, additional resistors (between DI and DO and on the red channel) and the LDO now on the down side.

I don't know much about circuit design so I can't pretend to understand this but I'm hoping the lights will stay lit this time!

The type of chip is not marked on the side of the case (arrow as before) and Ray tells me that whilst the wiring has changed (positive and data now opposite) this is inside the case so the outside wiring is the same as before.

I hope thats true! Wish me Luck.


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Look at the first pixel and see if the number is there as that's where it is on the string I'll be testing. If it's not there it may have been made before Ray got the mold with the ID slug.

I've only done some basic tests. I had planned to have started this week but can't yet as my controller is tied up till the weekend.


Reply
Posts: 23
(@hauvega)
Eminent Member
Joined: 18 years ago

How about leaving them out in the elements with power applied? You really do not need a signal applied. I still would like to see an anaylsis of the pixels after a year of being exposed to the elements. What type of conformal coating is applied? Is it silicone based or some other type? What is the texture of the blank plastic sample pixel mold?


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Any updates

Sent from a Galaxy 4s in the North Pole


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Not yet, I had to wait till I got the video shot and I could take down the lights and free up the controller. I'm putting together a test sequence and will run the lights out doors hanging from the roof in the back yard.

By the way, Ray made a test mold of one in green. The body is too light but the wire is close. What do you all think, should the wire be darker? BTW, Ray told me that they made the body color just for show. He put some green toner in the plastic. 😆


Reply
Page 18 / 26
Share: